Health and Safety in the Laboratory
This material was produced under grant number SH-17035-08-60-F-11 from the Occupational Safety and Health Administration, U.S. Department of Labor. These
materials do not necessarily reflect views or policies of the U.S. Department of Labor, nor does mention of any trade names, commercial products, or
organizations imply endorsement by the U.S. Government.
2
Objectives
After this session, you will know:
• How to identify health and safety hazards of school laboratory work
• Health and safety measures your lab should have in place
• How best to protect yourself from hazardous exposures
• The requirements of OSHA’s Laboratory Standard
3
Laboratories in the News
Two dozen fire departments responded yesterday to Rocky Point High School after a science teacher was burned when a chemical reaction in a science lab touched off a small explosion. The teacher, Anthony Nobre, 26, of Medford, suffered burns over his arm, neck and face. He was taken to University Hospital in Stony Brook, where he was listed in satisfactory condition, according to a spokeswoman. The blast erupted as Nobre put crystallized sodium into a container holding a small amount of water. The Brookhaven fire marshal was conducting an investigation and recommended that the building be closed today.
Detroit’s Miller Middle School will be closed today and possibly Wednesday while health and environmental officials finish cleaning up a small amount of mercury that students spilled in a science class just before school was dismissed Monday. Students apparently were playing with about an ounce of the toxic substance in a sealed vial when it spilled, said a district spokesman Stan Childress. About 30 students and a teacher were present, he said. There is a possibility that students may have tracked through the mercury because some beads of the substance were found in the hallway, Childress said.
4
Why All the Fuss?
Exposure to Hazardous Chemicals Can Result in acute or chronic health effects
Acute – occurring within hours or days of exposure
Chronic – occur after exposure over many years
5
Engineering: Removes or Separates Hazard from Person i.e.:
• Local Ventilation (Fume Hoods)• Chemical Substitutions
Administrative: Procedures that Limit Contact with Hazard i.e.:
• Job Rotation
• School Staff Training
• Good Housekeeping
6
Personal Protective Equipment (PPE)
PPE Should Be Considered Only After Administrative and
Engineering Controls Have Been Applied.
Minimum Recommended PPE:
Chemical Resistant Gloves, Splash Proof Goggles,
Lab Coat, Face Shield, and Rubber Apron when Necessary
7
PPE: Glove Selection
Should be based upon:
• the chemical composition of the substance you are working with
• the properties of the glove material.
Find Out More about Glove Selection by Reviewing Material Safety Data Sheets (MSDS) or from Glove Supply Companies.
8
OSHA’s Laboratory Standard
• Protects staff who use and handle hazardous chemicals in laboratories
• Requires your School to:– Determine staff exposure to any
substances regulated by the standard – Conduct initial training & additional
training if a new hazard is introduced into the lab
– Develop a Chemical Hygiene Plan
9
Training Requirements
Labs are required to supplement course material with site-specific information & training including:
•Specific Work Practices•Chemical hygiene plan/lab manual•Location & availability of MSDSs•Specific lab safety work practices or SOPs•Training whenever new hazards are used in the lab
•Personal Protective Equipment•Instruction on appropriate PPE & how to use it•Location & availability of PPE & maintenance of reusable PPE
•Lab Equipment•Location & operation of eyewash &/or shower stations
•Use of fume hoods, storage cabinets, refrigerators & other engineering controls
•Waste Handling and Spill Response•Chemical waste handling & disposal procedures•Location & availability of spill kits & emergency checklists•Spill response procedures
10
Chemical Hygiene Plan
• Must Include:• Designation of a Chemical Hygiene Officer• Exposure control measures• Measures to ensure properly functioning
fume hoods & equipment• Staff training on hazard awareness &
measures available to protect themselves• Provisions for medical consultation &
examination• Respiratory protection program• Recordkeeping procedure• Hazard identification system
11
Safe Practice: Maintain a Chemical Inventory!
Conduct a yearly inventory of chemicals and update the file of material safety data sheets (MSDS) to prevent the accumulation of orphaned chemicals
Some of these chemicals become unstable, react with the container, slowly degrade or evaporate
12
You Have the Right to Know!
OSHA’s Hazard CommunicationStandard requires that
ALL Containers Must be Labeled With:
Chemical Name & Physical/Health Hazards
Name & Address of the Manufacturer & Emergency Contact Numbers
100 Main St., Philadelphia, PA
1-800-555-1212
13
Types of Labels
NFPA Diamonds and HMIS Bars are Color & Number Coded with Hazard Information
DOT Symbols Are Usually Found on Shipping Cartons
14
Material Safety Data Sheets (MSDS)• An MSDS Must Be on File & Available for Each
Chemical in the Lab.• An MSDS lists:
– Product Identity– Hazardous Ingredients– Physical Data– Fire & Explosion Hazard Data– Reactivity Data– Health Hazard Data– Precautions for Safe Handling & Use– Control Measures
16
Supply Air Diffusers & Room Air Exhausts Should be
Located So As to Avoid Intake of Contaminated Air
Windows Should be Operable
General VentilationGeneral Ventilation
17
Local VentilationFume Hoods Used For Operations that Give Off:
• Noxious Odors• Flammable or Poisonous Vapors
HOW DOES YOUR VENTILATION MEASURE UP?
18
Safety Showers and Eyewashes
Must Be Available in All Lab Areas That Use or Store Chemicals Which Are Corrosive or an Irritant to the
Eyes or Skin
Combination Eye Wash & Drench Hose Units at the Sink are Now
Available
19
Match the Extinguisher to the Risk!
Fire Extinguishers Must Be:
Clearly labeled to indicate the types of fire they are designed to extinguish.
Visibly inspected monthly and maintained annually.
Class ABC Extinguishers Should Be Located:
–At the Laboratory Exit–Within 50 Feet of Any Point in the Lab.
Class D Extinguishers Are Required for Combustible Metals.
20
Means of Egress/Exit
Two or more well- marked & unobstructed
evacuation exits are recommended in a lab.
21
It’s Shocking!
There should be no accessible live, exposed electrical wiring.
Consideration should be given to installing ground-fault circuit interrupters on electrical circuits within 6 feet of water sources.
Electrical Safety in the High School Lab
22
Chemical Storage
Safe Storage of Chemicals is a Necessity in Every School Laboratory!
Minimizes Exposure to Students and Staff to Corrosive and Toxic Chemicals
Lessens the Risk of Fire Prevents the Mixing of Incompatibles & the Creation of
an Emergency Situation
23
The “Don’ts” of Chemical Storage!
Avoid storing any chemical above eye level
Don’t store incompatible chemicals together
Don’t store chemicals near sources of heat or sunlight
Don’t store chemicals in the hoods or acids on metal shelves
Avoid storing anything on the floor, especially glass bottles
26
Ideal Storage Area Set-Up
AcidsNA, LI
Oxidizers
Bases
Flammables Cabinet
Metal Salts
Nitrates
Spill Materials
Room Should Have:
•Eye Wash
•Safety Shower
•Emergency Phone
•Fire Extinguisher
Dry Chemical
s
27
– Organic Solvents
– Acids
– Alkalis (Bases)
– Mercury
Be Prepared for Small Incidental Spills
Proper Incidental Spill Control Equipment Includes:
Spill Control Materials Such As Spill Control Pillows, Pads, Booms, etc. Scoops, Brooms, Pails & Bags Absorbent – such as Diatomaceous Earth Neutralizers – for Acids & Alkalis Mercury Spill Control Kit
Chemical Categories Found in Most Secondary Schools Include:
28
Certain Spills Aren’t for Quick Clean-up
• As a science teacher or lab specialist, you should only respond to incidental chemical releases, or small spills.
• For large or especially hazardous spills: – Quickly assess whether there are any
injured persons and attend to any person who may have been contaminated.
– Follow the notification, evacuation and emergency medical treatment procedures for your school.
– Evacuate the immediate area until the hazardous release has been characterized and controlled.
29
Waste Chemical Disposal
• Requires:
– Proper storage– same rules apply – make sure waste chemicals are compatible
– Proper labeling – tags should be placed on bottles name of chemical
– Pre-planning – know what waste you’re creating prior to carrying out experiments; minimize purchases
– Record-keeping – of all waste chemicals on hand and those already picked up for disposal