3D Harness-Design-Bridge
Technische Informatik GmbHLämmerweg 55D - 89079 Ulm
Telefon: +49 7305/9309-0Fax: +49 7305/9309-99E-Mail: [email protected]: www.cim-team.com
3D Harness Bridge
The 3D Harness Bridge is designed for tranferring data between E³.cable designs and 3D Harness Design Systems
Electrical data from E³.cable• connectors / devices• pins• connectivity• attributes of wires and cables
Data from the 3D Systems• length information
Supported Systems
EMbassy
Pro/ECabling Design
V4V5
Routing
Harness Design
Functionality in the 3D-System
The functionality depends on the 3D System used
Normally supported functions are
• Calculation of wire length• Control of bend radius information• Collision control• Placement of Fixings
Supported E³.series ProEngineer versions
The following versions of E³.series and Pro/E are supported for the interface
• Pro/E 2001 build 2004290• Pro/E Wildfire 1.0 build M240 or later• Pro/E Wildfire 2.0 build M100 or later• E³.series 2004 build 330 or later
Structural Data
Connector / Device information
• Device designation• Component name• Serial number• Pin names• Additional attributes
Structural Data
Wire / Cable information
• Wire name• Wire color• Outer Diameter• Bend radius• Additional attributes
• Length information from the 3D system
Prerequisites in E³.cable
Specific attributes for components and pins
Component (Owner: Component)• Type• ArticleNumber (only if selected)• ModelName (only if selected)
Pin (Owner: Pin)• EntryPort• .CONNECTOR_NAME (only if selected) (Internal Device Designation)• InternalLength• PinGrouping
Prerequisites in E³.cable
Specific attributes for wires / cables
Cable (Owner: Cable)• MinimumBendRadius• Diameter
Conductor/Wire (Owner: Cable Conductor)• MinimumBendRadius• Diameter• WireId
Prerequisites in ProE
Mapping of E³.series Component and 3D Model
Mapping through name or attribute ModelName
E³.series 3D Model
Handling
Pro Engineer XML-Export from E³.cable
ProEngineer interface menu
ProEngineer interface – select wires / cables
ProEngineer interface menu
ProEngineer interface – options
ProEngineer interface menu
ProEngineer interface – default values
Default values• used if attributes left
blank• ProE does not allow
blank values
ProEngineer actions
Please ask your ProEngineer specialist
• What prerequisites are necessary• How to read in the XML structure• How to route / control in ProEngineer
DMU in 3D Systems
Automobile Door Harness
Questions and Answers
Any questions ?
CAE solutions
... your cabling solution!
Technische Informatik GmbHLämmerweg 55D - 89079 Ulm
Telefon: +49 7305/9309-0Fax: +49 7305/9309-99E-Mail: [email protected]: www.cim-team.de