Installation Instructions For DOCMT & DOCMT112006 + Newer Dodge Charger Mount Kit For 900 Series Consoles

1. Remove factory mounted base plate and brackets.

2. Install Lund front bracket using the (3) factory studs and nuts.

3. Install Lund rear bracket assembly using (2) factory bolts. The top half of therear assembly can be offset to any of the side holes of the bottom half to allowfor proper positioning of the rear bale bracket.Optional: (2) 3/4” sheet metal screws can be added through the back slotsof the rear bracket for extra strength. Be sure to install theses in line with thefactory bolts to ensure that they only go through the upper sheet metal, notthrough to the outside of the vehicle.

4. Attach bale brackets to front and rear mounts using provided 5/16” bolts, lockwashers and flat washers.

5. Position the console between the front and rear bale brackets and secure with5/16” bolts, lock washers and flat washers into the pems in the sides of the console.Note: If pems don’t line up when console is in desired position, new holes willneed to be drilled.

SPECIALISTS IN EMERGENCY VEHICLE PRODUCTS SINCE 1978 • DESIGN, MANUFACTURING, DISTRIBUTION AND INSTALLATION

Rev. 6/06