YAMAHA RHINOBILLET SIDE MIRRORS (Y074110)

INSTALLATION INSTRUCTIONS

Please read these instructions before installation to avoid injury to yourself or damage to your ATV.

INCLUDED IN KIT:

(2) MIRROR/MOUNT ASSEMBLIES INSTALLED BILLET SIDE MIRRORS

INSTALLATION:

1. With (1) of the mirror/mount assemblies supplied in your kit, remove the mounting screws and separate the lower half arc section of the billet mount from the main section.2. Position the two sections of the mount so that it wraps the tubing of the roll cage on either the left or right side of your Rhino.3. Position the main section of the mount with the attached mirror, so that it is situated on the outside of the Rhino roll cage. The mirror lens should be facing the driver/passenger.4. Re-install and tighten down the mounting screws through the lower half arc section of the mount. 5. Using the swivel on the mirror/mount assembly, adjust the mirror to your liking.6 Repeat procedures 1-5 for the other side mirror installation.

CUSTOMER SERVICE:

For further information, please contact Pro Armor at 951-270-0559

Y074110