Summary

This measuring simple jig fits between the top of the z-motor mountingplate and the bottom of the x mounts. When it fits about the same on bothsides you should be good to go! -Alternatively you could make two ofthese and lower your z until it bottoms out on both.

My printer as it is setup up currently rarely needs any adjustment if thebed is well leveled once. I just do a quick 4 second check with the jig afterhoming and about 10% of the time I may need to turn a z motor a click ortwo.

3D Printers > Other Accessories

zonestar zheight tronxyp802ma tronxyp802m

tronxyp802e tronxyp802 tronxy802 bedleveling bedleveler

bedlevel aneta8 anet

J John S

Z Height Jig

VIEW IN BROWSER

updated 27. 11. 2019 | published 27. 11. 2019

3D M

ODEL

ONLY

Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES

364.8 KBupdated 27. 11. 2019

Category: 3D Printer Accessories PrintSettings

Printer: Tronxy P802E

Rafts: No

Supports: No

Resolution: .2

Infill: ~10%

Notes:

Flip the model flat on its back. Then scale the length to your needs. It is100mm long to be easy to scale. My setup happens to require 77MM. So Iwould scale in one dimension to 77%.

Find source .stl files on Thingiverse.com

The Author has not uploaded any print files.Try to search in User print files section or generate and upload yourown.

License

This work is licensed under a Creative Commons (4.0 International License)

z_jig_100mm.stl

Attribution

✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✔ | Commercial Use ✔ | Free Cultural Works ✔ | Meets Open Definition