Upload
bruce-garlock
View
219
Download
0
Embed Size (px)
Citation preview
7/31/2019 Xsraid Memory
http://slidepdf.com/reader/full/xsraid-memory 1/5January 28, 2003
Xserve RAID
Memory DIMM
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note: A memory DIMM is located in each of two controller modules at the back of the
Xserve RAID enclosure. To replace a memory DIMM, you must first shut down Xserve
RAID and remove the controller module from the enclosure. See the Xserve RAID User’s
Guide for shutdown instructions.
Tools Required
The only tool required for this procedure is a Phillips screwdriver.
Removing the Installed Memory DIMM
1. Press apart the two latches on the back of the controller module.
2. Holding the module by the latches, pull it straight out of the enclosure. (Figure 1)
Figure 1
7/31/2019 Xsraid Memory
http://slidepdf.com/reader/full/xsraid-memory 2/5Xserve RAID Memory DIMM - 2
3. Remove the two screws on the front of the case, slide out the bottom half of the case,
and place it on a sturdy, flat surface. (Figure 2)
Figure 2
Note: The controller card is attached to the bottom of the controller module case. Do not
attempt to separate the card from the bottom case.
7/31/2019 Xsraid Memory
http://slidepdf.com/reader/full/xsraid-memory 3/5Xserve RAID Memory DIMM - 3
4. Release the two latches that keep the memory DIMM in place. (Figure 3)
5. Holding the DIMM by the edges, disconnect it from the controller card.
Figure 3
7/31/2019 Xsraid Memory
http://slidepdf.com/reader/full/xsraid-memory 4/5Xserve RAID Memory DIMM - 4
Installing the Replacement Memory DIMM
1. Insert the replacement memory DIMM at an angle into the DIMM connector on the
controller card. Once the DIMM is connected, rotate it down flush with the controller
card until you feel the latches snap into place. (Figure 4)
Figure 4
2. Slide the top of the controller case back onto the controller card.
3. Replace the two screws on the front of the case.
4. Hold the controller module by the latches and carefully slide it into the enclosure until
you hear it click into place.
5. Press the two latches toward each other to seat the module in the system.
7/31/2019 Xsraid Memory
http://slidepdf.com/reader/full/xsraid-memory 5/5Xserve RAID Memory DIMM - 5
Apple Computer, Inc.
© 2003 Apple Computer, Inc. All rights reserved.
This document is protected under U.S. Copyright Law and International Treaties, and no
part of this document may be reproduced in any form without written permission fromApple.
Apple is not responsible for typographical, printing, or inadvertent errors.
Apple Computer, Inc.
1 Infinite Loop
Cupertino, CA 95014-2084
USA
+ 1 408 996 1010
http://www.apple.com
Apple, the Apple logo, Mac, Macintosh, and the Mac logo are trademarks of Apple
Computer, Inc., registered in the U.S. and other countries. Xserve is a trademark of Apple
Computer, Inc.