33

3331

34

circle

32

30

1 2

34

Each propeller by thetwo adhesive

Sliced into propeller blade angle required

Each side of the fuselage is made by a double bond Note proeller support

bracket holes

Pay attention to the hole of propeller’s support bracket

Note that the main beam of the wing bending

Note jack’s position

Note jack’s position

Jack on the wing below the main beam

Jack on the wing below the main beam

Note the bending of wing’s main beam

Propeller assembly bracket(making 2 sets)

Note the leadingedge of the socket

Assemble pilots card bit

Do not plug the wing between pillars

Note the direction of the wing between the strut

Jack on the wing below the main beam

Assemble the wing’s main beam and wing ribs

Completed main beam of the wing

2pcs unnumbered wing ribs combo

unnumbered wing ribs

unnumbered wing ribs

unnumbered wing ribs

Wing Tip

Wing Tip

Completed main beam of the wing

Main beam of the wing(right)

Wing’s main beam(bottom right) Wing’s main beam

(bottom left)

Wing’s main beam(bottom left)

Connection of wing’s main beam

Fuselage/Top wing

A combination of the propeller drive chain

Two unnumbered ribs combination use only in the middle of the wing,each of the main wing only need one.Unless specially marked ribs,all the rest ribs are unnumberesd.

Installation for the leading edge and trailing edge of the wing.

1

2

6

65

5

5

5

3

34

4

26

25

Note the bending of wing tip must be consistent in lower wing

211521

22

23/24

19

28

27

29

20

Wright Flyer I INSTRUCTION MANUALThe Wright Brother’s 1903 Wright flyer

Combination of vertical tail16

16

10

11

14

13

14

13

Pulling Wire Diagram

Installation Position of Emulational Engine and Pilot.

ToolsInstallation of vertical tail

Wright Flyer I INSTRUCTION MANUALThe Wright Brother’s 1903 Wright flyer