PRE-OPERATIONAL SAFETY CHECKS

1. Workspaces and walkways are checked to ensure no slip/trip are present.2. All guards and safety shields are ensured are in position before starting the grinder.3. The wheels are ensured that do not touch the work rest and that the gap between wheel

and rest is no greater than 1.5mm.4. The wheels are checked running true and are not glazed or loaded.5. The operation of the ON/OFF starter is located and ensured you are familiar with.6. faulty equipment Must not be use. Any suspect machinery is reported immediately.

OPERATIONAL SAFETY CHECKSFirstly, stand to the side of the wheels when starting up.

Secondly,let the wheels gain maximum speed before starting to grind.

Thirdly, Do not grind on the side of the wheel.

Fourthly, small objects must not be held by hand.

Fifthly, never leave the machine running unattended.

Sixthly, do not bend down near the machine whilst it is running.

Seventhly, never force the workpiece against a wheel.

Eighthly, slowly move the workpiece across the face of the wheel in a uniform manner.

Nintethly, Coolant spilt on the floor should be immediately absorbed.

Hierarchical step

FLOW CHART

BENCH GRINDER MACHINE

Ensure area around grinder is clean and

well maintained

Check abrasive wheel for cracks or

flaws

Put the wheel into flange of grinder

machine

Adjust tongue guard Close the eye shield

Switch on the bench Grinder machine

Allow grinder to reach full rpm

before grinding

Position yourself to avoid

overbalancing

Grinding ( do not grind soft

metal)

Done grinding

Switch off

Clean area and dispose of grinder particles

DONE

PRE-OPERATIONAL SAFETY CHECKS

GRAPHIC

OPERATIONAL SAFETY CHECKS