© QM Software WORK-INSTRUCTIONWELDER

Procedure No.:6.2.2Rev. no.: 0

Project: Order: Section: Page: 1 of: 1

1. WORK-INSTRUCTION

Title:Reports to:Responsibility:Main Function:

Welder *Welding ForemanControl of own workWelding of components

2. QUALIFICATION REQUIREMENTS

The welder shall be certified according relevant part of EN-287/ISO 9606 or EN 1418 according relevant welding process, material-group, welding position and material dimensions.* The welder who are using manual welding equipment or equipment for mechanized welding can be certified according EN 287/ISO 9606. For fully automatic welding equipment the welder must be certified according EN 1418

3. Responsibility.The welder has the responsibility for the following activities in relation to welding:

1. Receive and understand the working instructions/work order

2. Perform the welding as described in the WPS, work instructions or according verbal instructions.

3. Inspect and verify own work

4. Special items affecting the quality of the weld shall be reported to relevant supervisor

5. Create, if relevant, closing remarks or reports for the job

4. References:13.2 Control and verification before welding13.3 Control and verification during welding13.4 Control and verification after welding

Created by: Approved by: Date: Manual no.: