Upload
votuyen
View
224
Download
2
Embed Size (px)
Citation preview
English
2
WitboxCura Manual
CONTENTS
3 Configuring your Witbox (simple extruder)
5 Installing the new firmware
5 Firmware correctly updated
English
3
Witbox Cura Manual
UPDATING WITBOX FIRMWARE FROM CURA
Configuring your Witbox (simple extruder)
Open the configuration of your printer. To do that, you will have to select the machine which you configured when installing Cura (in this case, Witbox) and go to Machine>Machine settings...
Check the dimensions of the platform and configure the USB port. For an extruder Witbox the configuration is the following:
Maximun width (mm): 297
Maximun depth (mm): 210
Maximun height (mm): 200
Extruder count: 1
Gcode Flavor: RepRap (Marlin/Sprinter)
To configure the USB connection, select the characteristics of the section Communication settings:
Serial port: COM1, COM2... (select the port of your printer)
Baudrate:115200
You must leave the other options unmarked or at zero.
When it is configured, press OK and go again to Machine>Install custom firmware...
English
4
WitboxCura Manual
Select the precompiled firmware that you wish to install.
You can download it from the downloading website of the Witbox: http://www.bq.com/descargas-witbox.html
English
5
Witbox Cura Manual
Installing the new firmware
The firmware of the Witbox will update itself. This operation can take several seconds.
Firmware correctly updated
This message will appear when the installation of the firmware has been completed.