Which Standards might apply to these hazards

Some suggestions:FP Subpart M – employees on the wall FP Subpart L – employees on the scaffoldAccess – Subpart L, or, if they were using an extension ladder, Subpart XSubpart E PPESubpart D Health/Hazcom

Which Standards might apply to these hazards

Some suggestions:Sub M – working on the structureSub L – working on the scaffoldSub X – ladder construction and installationSub Q – impalement hazards, adequate strength of formwork systemsSub E - PPE

Which Standards might apply to these hazards Some

suggestions:Sub M – Fall protection, harness useSub L – scaffold guardrails, boomlift safetySub T – demolition operationsSub H – Material handling

Which Standards might apply to these hazards?

Some suggestions:Sub L – scaffold construction, guardrailsSub X – ladder installation and use

Which Standards might apply to these hazards?Some suggestions:Sub L – scaffold platform construction, access, fall protectionSub E - PPE – hardhats backwards, lack of safety glassesSub D – potable water supplySub M – trip and fall hazards, ramps into excavationSub P – excavation safety, sloping

Which Standards might apply to these hazards?

Some suggestions:Sub L – scaffold platform construction, capacitySub X – ladder construction and installationSub Q – impalement hazardSub M – fall protection from floor into hole, or over side of floor

Which Standards might apply to these hazards?

Sub L – mobile scaffold useSub M – fall protection (note cables in foreground, it is 80’ to the ground over the cables), anchorage point capacityRolling mobile scaffolds can be inherently dangerous, and have very specific requirements for safe use, especially when employees remain on the scaffold. Be sure to consult the applicable requirements in Subpart L.

Which Standards might apply to these hazards?

Some suggestions:Sub L – Ladder jack usage, fall protection from the systemMaximum height of ladder jack scaffolds is 20’Sub M – Fall protection from the roof (steep roof)Sub E – PPE (or lack thereof)Sub X – Ladder usage, installation

Which Standards might apply to these hazards ?

Some suggestions: Sub L – Aerial work platform usage, fall protection requirementsSub M – Fall protection at roof edgeSub E – PPESub C – Training, qualified, competency, effective safety program – this is the foreman on the jobsite, not leading by exampleHarnesses are required at all times when using boom lifts