Wheelloader e a4

8/11/2019 Wheelloader e a4

1/10

Special Vehicle Series:01

WA600-6

PatternWheel Loader

http://www.canon.com/c-park/en/

View of completed model * This model was designed for Papercraft and may differ from the original in some respects.

1/43 scale Editor:

The WA600-6 is a large wheel loader. A wheel loader is a piece of constructionmachinery used to scoop up earth and sand and load it onto dump trucks and otherpieces of machinery. The loader can be used to move earth and sand by raising thebucket (which is installed in front). In comparison with previous models, the WA600-6 features higher specifications in terms of bucket capacity, engine output rating,and operating mass. With the latest fuel-conservation technologies, including newlydesigned hydraulic systems and engine technologies, this model offers enhancedproductivity and energy efficiency.

Bucket capacity:

Overall length:

Overall width (bucket width):

Overall height :

7.0 m3

11,870 mm

3,685 mm

4,460 mm

Parts list (pattern): Ten A4 sheets (No. 1 to No. 10)No. of Parts: 78

Build this model with careful reference to the Assembly Instructions.

* If you prefer that the rear sides of the paper parts not be white,

print the two optional reverse-side printing sheets on thin papersuch as standard printer paper and adhere these to the reversesides of sheets no. 6 and no. 10 using spray adhesive, then buildthe model as described in the instructions.


2/10

PatternWheel Loader


3/10

http://www.canon.com/c-park/en/ Keisuke Saka

CAUTION

Do not hit other people with the pointed edges.

Doing so could result in injury. Adults should

make sure that children observe this caution.

PatternWheel Loader


4/10

PatternWheel Loader


5/10

PatternWheel Loader


6/10

* If you prefer that the rear sides of the paper parts not be white, print the optional reverse-side printing sheet (yellow) on thin paper such as standard printer paperand adhere it to the reverse side of this sheet using spray adhesive, then build the model as described in the instructions.

PatternWheel Loader


7/10

PatternWheel Loader


8/10

PatternWheel Loader


9/10

PatternWheel Loader


10/10

* If you prefer that the rear sides of the paper parts not be white, print the optional reverse-side printing sheet (black) on thin paper such as standard printer paperand adhere it to the reverse side of this sheet using spray adhesive, then build the model as described in the instructions.

Special Vehicle Series

Wheel LoaderWA600-6

PatternWheel Loader

Documents

Wheelloader e a4