Victoria Falls - serenityhealth.com · Victoria Falls Instructions Fountain Installation and Care Phone: 800.455.9408 Email: [email protected]

Victoria Falls

Instructions

Fountain Installation and Care

www.windandwaterworx.com Phone: 800.455.9408 Email: [email protected]

Parts List

A: Water DisperserB: Copper ValenceC: Slate PanelD: Pan BracketE: Base Pan


A

H

B

C

D

E

F

G I

F: Rock TrayG: River RocksH: Installation HardwareI: Fountain Pump

Fountain Assembly

1. Determine fountain location and attach water disperser to wall. Insure disperser is level.


2. Measure down 25 ½” from the center of the bottom of the disperser pipe and make a mark

3. Install pan bracket to wall making sure the top of the bracket is on the mark made in step 2, insure bracket is level.


4. Place base pan on bracket, insure center of the base pan (notch in back on pan), is centered below disperser pipe. Mark with pencil the two holes in the base pan at the top of each end. Install E-Z anchor (if stud disregard). Replace base pan, align with two holes, secure with E-Z anchor screws.

5. Place pump in base and insure pump cord is fed behind the base pan through the notch provided. Connect pump to hose connection attached to disperser.


6. Using a level or other sturdy flat item and place across the base pan. Place slate panel on level (or flat surface). Fold copper straps over disperser pipe and attach with provided hardware.


7. Place rock tray in base pan. Install provided copper clips to insure slate panel is seated in the back of the base pan.


8. Fill base pan with water, do not over fill. Plug in pump and make sure water flows evenly. Use a wet sponge to insure the entire slate panel is wet.


9. Unplug fountain, slide copper valence between copper strap and slate panel. Fill rock tray with river rocks.

ENJOY

Documents

Victoria Falls - serenityhealth.com · Victoria Falls Instructions Fountain Installation and Care Phone: 800.455.9408 Email: [email protected]