Turbine Data Sheet

VP No. SEP-15-101-UW-P-41A-G-0015

Item No. UW-P-41A Page No. 1 OF 2 Rev. No. 3

Job No. 110670 Project Title Saudi Elastomers Project U&O, Carbon Black and MTBE Decomposition Unit Client Al-Jubail Petrochemical Company (KEMYA) Location Jubail Industrial City, KSA

No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, without permission in writing from KEMYA or DAELIM

Turbine Data Sheet Saudi Elastomers Project

U&O, Carbon Black and MTBE Decomposition Unit P.O. NO. PO-110670-15-101-001-A01 P.O. DESCRIPTION Centrifugal Pumps(API 610 10th, OH2)

ITEM NO. UW-P-41A ITEM DESCRIPTION Condensate Pump with S.T DOCUMENT NO SEP-15-101-UW-P-41A-G-0015 DOCUMENT TITLE. Turbine Data Sheet DAELIM INDUSTRIAL CO., LTD. SEOUL, KOREA Job. NO. 110670 A Approved without comments

AAN Approved As Noted RFC Returned for Correction

U&O CB MTBE SIGNED BY : DATE :

PURCHASER PERMISSION TO PROCEED OR REVIEW TAKEN ON VENDOR PRINTS SHALL NOT RELIEVE VENDOR FROM ITS RESPONSIBILITIES OR LIABILITIES UNDER THE PURCHASE ORDER.

SULZER KOREA

3 2014-09-05 ISSUED FOR APPROVAL W.H.CHOI W.H.CHOI S.H.CHA

2 2014-03-19 ISSUED FOR APPROVAL W.H.CHOI W.H.CHOI S.H.CHA

1 2013-11-18 ISSUED FOR APPROVAL W.H.CHOI Y.C.JO K.J.LEE

0 2013-06-11 ISSUED FOR APPROVAL W.H.CHOI Y.C.JO K.J.LEE

REV DATE DESCRIPTION PREPARED BY CHECKED BY APPROVED BY

0

1

2

2

JOB NO. ITEM NO.

PURCHASE ORDER NO.GENERAL PURPOSE STEAM TURBINE DATA SHEET NO.

API 611 5TH EDITION DATA SHEET REVISION NO. DATESI UNITS (BAR) PAGE BY CHECKED APPROVED

1 APPLICABLE TO: APPLICABLE STANDARD: UNITS OF MEASURE:

2 FOR UNIT

3 SITE NO. REQUIRED

2 4 SERVICE DRIVEN EQUIPMENT5 MANUFACTURER MODEL SERIAL NO.

6

7

8

9

13

14 APPLICATION IS:

15 WIDE SPEED RANGE RAPID START

16 SLOW ROLL REQUIRED HAND VALVES API 611 OTHER17 OPERATION

18

19

20 LOCATION (6.1.14) TURBINE TYPE

21 AMBIENT TEMP MIN MAX C NO. OF STAGES WHEEL DIA MM

22 UNUSUAL CONDITIONS (6.1.14) ROTOR CONSTRUCTION

23 ARRANGEMENT

24 AREA CLASSIFICATION NEC CLASS 1 DIV 2 GR CD T3 BLADING25 CASING SPLIT

26 CASING SUPPORT

27 CONTROL POWER V PH HZ VERTICAL JACKSCREWS FURNISHED

28 AUX MOTORS V PH HZ

29 COOLING WATER PRESS BARG DP BARG

30 FLOW LPM DT C TRIP VALVE

31 ALLOW. SOUND PRESS. LEVEL (6.1.12) INTERSTAGE SEALS

32 END SEALS

33

34 INLET PRESS BARG

35 INLET TEMP C TYPE RADIAL BEARINGS

36 EXHAUST PRESS BARG TYPE THRUST BEARINGS

37 STEAM CONTAMINANTS LUBE OIL VISCOSITY ISO GRADE

38 LUBRICATION

39 ALLOW SPEEDS, RPM MAX MIN OIL MIST

40 MAX CONT SPEED, RPM OIL MIST SYSTEM

41 TRIP SPEED, RPM BLADE TIP VEL. M/S BEARING HOUSING OILER TYPE

42 FIRST CRITICAL SPEED, RPM BEARING HOUSING SEAL

43 EXH TEMP NORMAL C NO LOAD C SEAL SUPPLIER

44 POTENTIAL MAX POWER KW

45 MAX NOZZLE STEAM FLOW KG/HR MAX ALLOWABLE PRESS BARG

46 ROTATION FACING GOVERNOR END MAX ALLOWABLE TEMP C

47 VERTICAL DRIVEN EQUIPMENT THRUST HYDRO TEST PRESS BARG

48 VERTICAL TURBINE THRUST CAPACITY

49 WATER PIPING REQUIRED

50 FURNISHED BY REMARKS

51 OIL PIPING REQUIRED

52 FURNISHED BY

53 AUTO DRAIN SYSTEM REQUIRED

54 FURNISHED BY

106.8 27.6

NO

NO

YESELLIOTT

7585 48.2 17.2COUNTER-CLOCKWISE 482

311 360

143 CASING DESIGN INLET EXHAUST

7750 ELLIOTT BEARING ISOLATOR (EBI)

32

TURBINE DATA PRESSURE1869 1513 NO

14.0 12.0 10.0 ANTI-FRICTION400

2056 48.81869

370 365

460 3

SLEEVE

INTEGRAL BODY80 dBA @ 1 M

STEAM CONDITIONS (6.1.4) CARBON RINGMAX NORMAL MIN45.0 43.0 41.0

60

457.2

CENTER LINE230 1 60 YES

2 ROWAXIAL

SALT ATMOSPHERE BUILT UPDUST ATMOSPHERE BETWEEN BEARINGS

YES YESCONTINUOUS

CONSTRUCTIONOUTDOOR UNHEATED W/O ROOF HORIZONTAL

0 50 1

RATED / NORMAL OPEN

NORMAL / NORMALCERTIFIED STEAM RATE

CLOSED

NO APPLICABLE SPECIFICATIONS

RATED @ MIN INLET & MAX EXHAUST

OPEN

54.2

58.3

62

DUTY, SITE, AND UTILITY DATA OTHER / NORMAL CONDITIONSSPARED

12 OTHER (6.1.4)

10 NORMAL 91.7 1780

11 RATED 101 1780

ELLIOTT BYRHPE IIIB F302403

OPERATING POINTABSORBED POWER, SPEED,

RPMOPERATING POINT / STEAM

CONDITIONNO. HAND VALVES

OPEN

OPERATING CONDITIONS

45013020006DOC000000091721

2 24-Jul-14

AS BUILT API-611 SI UNITS (BAR)

1 OF 3 ONDO

STEAM RATEKW KG/KW-HR

Condensate Pump Steam Turbine

Al Jubail Petrochemical Co. (KEYMA) UW-PST-41AAl Sinaiyah, Saudi Arabia 1

CENTRIFUGAL PUMP

JOB NO. ITEM NO.

PURCHASE ORDER NO.GENERAL PURPOSE STEAM TURBINE DATA SHEET NO.

API 611 5TH EDITION DATA SHEET REVISION NO. DATESI UNITS (BAR) PAGE BY CHECKED APPROVED

1

2 HIGH PRESSURE CASING ASTM A-217 GRADE WC6 REMOTE TRIP SOLENOID3 TURBINE TRIPPED SIGNAL

4 EXHAUST CASING ASTM A-217 GRADE WC6 VACUUM BREAKER5 NOZZLES AISI 410 GRADE AUTOMATIC STEAM SEALING SYSTEM6 BLADING AISI 403 GRADE SEALING STEAM BARG C7 WHEELS ASTM 517 GRADE TYPE B GLAND VACUUM DEVICE WITH:8 SHAFT AISI 4140 GRADE SENTINEL WARNING VALVE9 SHAFT COATING UNDER PACKING INSULATION, TYPE:

1 10 MATERIAL STAINLESS STEEL TACHOMETER TYPE11 APPLICATION METHOD FLAME SPRAY MFR.12 THICKNESS 0.051 MM MOUNTED BY13 GOV. VALVE TRIM D2, NI-RESIST THERMAL RELIEF VALVES14 INLET STRAINER MESH SIZE #8 MESH

1 15 INTEGRAL TO TURBINE LOCAL GAUGE BOARD WITH PRESSURE GAUGES:16 THROTTLE STEAM FIRST STAGE

17 NOZZLE RING EXHAUST

18 INLET LIQUID FILLED GAUGES

19 EXHAUST INSTRUMENT PANEL

20 DRAINS HP

21 DRAINS LP

22

23 TYPE OF LUBE SYSTEM SUPPLIED

24 VENDOR FURNISH SYSTEM FOR

25 LOCATION

26 MAKE OIL SYSTEM TO BE:

27 MODEL

28 RATING (HP/100RPM) REMARKS

29 LUBRICATION

30 LIMITED END FLOAT

31 SPACER LENGTH

32 SERVICE FACTOR

33 COUPLING SPACER/HUBS MATL. FURNISH PROVISIONS FOR MOUNTING NON-CONTACTING

34 COUPLING DIAPHRAGMS (DISKS) MATL. VIBRATION PROBES

35 TURBINE VENDOR MOUNTS HALF COUPLING FURN. AXIAL POSITION PROBES NO. OF PROBES

36 COUPLING CONSTRUCTED TO MFR. MODEL

37 SEE SEPARATE DATA SHEET FURN. ONE EVENT PER REV PROBE

38 COUPLING BALANCED TO FURN. RADIAL PROBES NO. OF PROBES

2 39 TURBINE SHAFT MFR. BENTLY NEVADA MODEL 3300 nSV40

41 FURNISH BEARING METAL TEMP SENSORS FOR:

42 RADIAL BEARINGS THRUST BEARINGS

43 TURBINE MOUNTED ON MAGNETIC SEISMIC PROBES

44 FURN. BY: PERMANENT SEISMIC PROBES

45 EQUIPMENT TO BE MOUNTED MFR. MODEL

46 TURBINE VENDOR SUPPLIES MONITORS

47 UNGROUTED BASEPLATE AXIAL AND RADIAL PROBES

48 BEARING TEMPERATURE SENSORS

49 SUBPLATES REQUIRED SEE SEPARATE DATA SHEETS FOR DETAILS

1 50 REMARKS KEY PHASER ALSO SUPPORTED51

52

53 GEARBOX REQUIRED

54 FURN. BY:

55 APPLICABLE SPECIFICATION

56 GEARBOX DATA SHEET NUMBER

GEAR BOX

VIBRATION AND POSITION DETECTORS (7.4.4.3)

YESNO NO

NONO

MOUNITNG PLATES YES NO

YESYES 4

STRAIGHT - SINGLE KEY

SEE PURCHASER'S CONNECTION DRAWINGSEE PURCHASER'S CONNECTION DRAWING

EXTERNAL LUBE OIL SYSTEM

TURBINE DRIVEN

NO

COUPLINGS (7.2)

8

SIZE RATING FACING POSITION

YES

CONNECTIONS (6.4.2) YES

300 RF LEFT

YES YES4 600 RF RIGHT NO

NOYES

NONO

YESACOUSTIC BLANKET

2 24-Jul-14

MATERIALS (6.12) ACCESSORY EQUIPMENT BY VENDOR

DYNALCO SPD-100ELLIOTT

2 OF 3 ONDO

YESLIMIT SWITCH

DOC00000009172145013020006

MAGNETIC/SELF POWERED

JOB NO. ITEM NO.

PURCHASE ORDER NO.GENERAL PURPOSE STEAM TURBINE DATA SHEET NO.

API 611 5TH EDITION DATA SHEET REVISION NO. DATESI UNITS (BAR) PAGE BY CHECKED APPROVED

1

2 GOVERNOR TYPE TURBINE, AUX. EQUIP. AND SPARE ROTOR PREPARED FOR:

3 GOVERNOR MANUFACTURER TRI-SEN4 GOVERNOR MODEL 310SV OUTDOOR STORAGE NO LONGER THAN MONTHS5 SPEED RANGE REMARKS

6 SPEED SETPOINT ADJUSTMENT

7 LOCAL HAND SPEED CHANGER

8 REMOTE SPEED SETPOINT

9 VARIABLE10 SPEED TO RPM TO mA

11 SPEED TO RPM TO BARG

2 12 GOVERNOR POWER SUPPLY TESTS (8.3) REQ'D. WITN. (8.1.1) OBSVD.2 13 230 VAC PH1 60HZ HYDROSTATIC

14 REMOTE TRIP INPUT TO ELECTRONIC GOVERNOR DYNAMIC BALANCE

2 15 ELECTRONIC GOVERNOR SUITABLE FOR SLOW ROLL MECH. RUN h1 16 OVERSPEED TRIP PERFORMANCE

17 COMPLETE UNIT

18 No. ACTUATION DEVICES GEAR

19 MANUFACTURER SOUND LEVEL

20 MODEL AUX. EQUIPMENT

21 REMARKS RESIDUAL UNBALANCE CHECK

22

23

24 REMARKS

25

26 SUPPLY ENGR. DATA FOR L.ATERAL/TORSIONAL ANALYSES

27 BY OTHERS

28 CALCS AND/OR DATA FOR SEPARATION MARGIN PERFORMANCE CURVES

29 TRAIN TORSIONAL VIBRATION ANALYSIS PROGRESS REPORTS

30 TECHNICAL DATA MANUAL

31

32 PARTY HAVING UNIT RESPONSIBILITY TURBINE KG

33 ROTOR RUNNING CLEARANCES ROTOR KG

34 TURBINE UPPER HALF CASING KG

35 USE INSPECTORS CHECKLIST MAX MAINTENANCE (TUHC) KG

36 100% UT INSPECTION AFTER ROUGH MACHINING (ROTATING) T&T VALVE KG

37 CASTING SURFACE INSPECTION BASEPLATE KG

38 MISC. KG

39 CASTING WELD REPAIR APPROVAL (REQUIRED) TOTAL SHIPPING WEIGHT KG

40 WELD INSPECTION REMARKS

41 SPECIAL NDT INSPECTION

42

43

44 COMPONENT PENET.

45

46

47

48

49

50

51

NO

NO NOROTOR WHEEL NO YES NO NO NO NOROTOR SHAFT NO YES NO NO

STEAM PIPING YES NO NO NO NONO NO NO NOCASING YES

N/A N/A N/ASTM CHEST YES NO NO NO

NO

PART. GRAPHIC SONIC VED NESS

WIT-

NO NOT&T VALVE N/A N/A N/A

YES 1044

MAG. DYE RADIO- ULTRA- OBSER-

YESNO

YES

WEIGHTS931114

INSPECTION REQUIREMENTS 129NO

NO

YES YES NONO

129NO

YES

ENGINEERING REQUIREMENTS

YES

YES NO NO

DOCUMENTATIONYES

1513 1869 4 20

NONO

NOMECHANICAL BOLT NO

YES 4 YES YESYES YES NO NO

EXTERNALYES NO NO

YES

OPERATING RANGE CONTROL SIGNAL

45013020006

685% to 105%

ELECTRONICEXPORT BOX

DOC0000000917212

YES

24-Jul-143 OF 3 ONDO

GOVERNING SYSTEM PREPARATION FOR SHIPMENT