Model 00051838

Wireless Controller >>SCORPAD<< PS3

Controller Description

1. 1. Button directions

2. 2. Buttons analog

3. 3. Side buttons

4. 4. Function buttons

5. 5. Start button

6. 6. Select button

7. 7. Button TURBO

8. 8. Button PS3

Thank you for purchasing our product. We are convinced that high-quality product will bring you a lot of interesting moments while playing and completely meet your expectations. Before first use, please read carefully the instruction manual and keep it off. It may still be useful.

Controller functions1. 1. 2.4 GHz technology allows the transmission signal distance up to 15 m.

2. 2. linking Autoscan.

3. 3. The possibility to use up to 20 controllers at the same time.

4. 4. PS3 Home button to automatically open the menu (Software version 1.7)

5. 5. The possibility of programming features 12 buttons.

6. 6. Two analog buttons of the scope of 360 °.

7. 7. Sleep Mode.

8. 8. Playing time about 100 h (battery built into the controller)

System requires1. PS32. Port USB

Installing PS3

1. Receiver 2.4 GHz controller should be connected to available USB port on the console.

2. After pressing the mode button controller using AutoScan connects to the receiver placed in the USB port console.

3. If there will be no connection, disconnect the receiver from the port USB console and press the Select button and L3.

4. Connect the receiver to a USB port again.

5. Press the MODE key, the connection is made, and pad to pad assigns one of the (1 to 7).

FunctionsMODE button

MODE button on the controller operates the PS controller Sony PS3. Pressing the button for 2 seconds. you can go to the window PS3XMB

Sleep mode

To extend the life of the controller, and for reasons of economy energy, the controller is equipped with a function Sleep.

a) Sleep function allows you to switch the controller after 55 seconds. in state idle, if not within the receiver controller.

b) Sleep function lets you switch controller in idle state after 5 min. if not done by this time any movement.

To arouse the controller should press the MODE key.

LandingAttached to the supplied USB cable must be connected to the controller and to the console. To charge proceeded correctly both devices They must remain switched on. Charging time controller is min. 30 min. After about 2 h. the controller is fully charged.

About controls- The red LED on the receiver  - When blinks - no connection with the controller.

 - Off - created a connection to the controller.- The red LED on the controller  - When blinks slowly - no connection with receiver  - When flashing quickly - Charge the battery  - When flashes quickly when you press the buttons function Turbo for the button pressed is selected.  - When not illuminated - the connection with the controller is active.- The green LED on the controller  - When is blinking slowly - the controller in the charging state.

 - When flashing rapidly - charging error. - Off - finished loading.

COMMENTS

1. If some buttons during the game will not work should be check out the menu options and buttons assignment. You can perform the appropriate configuration buttons – see Manual game.

Precautions1. Never open up the housing of the controller. Repairs carried out by an authorized service.

2. Do not interfere with the electronic components of the device. IN Otherwise, it is connected with the loss of warranty.Deklaracja zgodnosci: wedtug dyrektywy R&TTE 99/5/EG pod www.hama.com