CAUTION

Use the Bluetooth earphones in the environment with the temperature between -0℃ and 45℃.

The product shall only be connected to a USB interface of version USB 2.0 or higher and that the connection to a power USB is prohibited.

For battery: risk of explosion battery is replaced by an incorrect type, dispose of used batteries according to the instructions.

To prevent possible hearing damage, do not listen at high volume levels for long periods.

FCC WARNINGThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

●

●

●

●

●

●

IMPORTANT SAFETY INFORMATIONDon't remove or replace the battery, including sensitive electronic components, including a battery, and can be damaged or cause injury if dropped, burned, punctured, crushed, disassembled, or if exposed to excessive heat or liquid. Don't use damaged batteries and electronic components.

Disposal and recycling information Don't treat the product and battery as household waste or into a fire. When you decide to dispose of the product and its battery, please follow the local environmental laws to handle the battery to avoid an explosion.

Medical device interference The product contains components and radios that emit electromagnetic fields and also contains magnets. These electromagnetic fields and magnets may interfere with pacemakers, defibrillators, or other medical devices. Maintain a safe distance of separation between your medical device and product. Consult your physician and medical device manufacturer for information specific to your medical device. Stop using the product if you suspect it is interfering with your pacemaker, defibrillator, or any other medical devices.

●

●

●

●

BUTTON CONTROLS RESETPRODUCT OVERVIEW

After the first connection, these earphones will automatically reconnect to the previous device after powering on.Earphones will automatically power off 5 minutes later without any operation after powering on.

POWER ON/OFF AND PAIRINGClear the pairing history of "Fly 9" in your device's Bluetooth setting.When the earphones are on, long press the volume-down and volume-up buttons for about 5 seconds until the purple light flashes.Earphones enter into pairing mode when red and blue lights flash alternately.Go to the Bluetooth setting in your device, find and tap "Fly 9" to connect.

1.

2.

Step 1.Step 2.

Step 3.Step 4.

Fly 9 Neckband Bluetooth EarphonesUser Manual

L

Write to support@linklike-audio.comContact us for any questions: ●

●

●

●

●

●

●

●

Fly 9 Neckband Bluetooth Earphones

② ③

④

⑤

⑥⑦⑧ ⑨⑨

⑩

①

First-time pairing: long press the multi-function button for about 2 seconds until "power on" voice prompts, then the earphones enter into pairing mode. Go to the Bluetooth setting in your device, find and tap "Fly 9" to connect.

Please fully charge the earphones before the first use. Recharge the earphones when "Battery Low" voice prompts.

Function

To power on

To power off

Connected

Connection Failed

Current Status

Power off mode

Power on mode

N/A

N/A

Operation

N/A

N/A

LED Indicator

Purple light flashes

Purple light flashes

N/A

N/A

Voice Prompt

Power on

Power off

Connecting

Connection failed

Notes:

Voice Prompt

N/A

Maximum volume: beep

Minimum volume: beep

N/A

N/A

Beep

Beep

Play/Pause music

Volume up

Volume down

Next track

Previous track

Answer/Hang up calls

Reject calls

Function Operation

Music

Calls

SPECIFICATIONS

Linklike is a trademark registered in the USA and other countries. All rights reserved.

WARRANTY CARD

CHARGING

Battery Low

Charging

Fully Charged

Red light flashes

Solid red light

Solid blue light

LED IndicatorStatus

Fit isssue

Pairing issue

Cut-in/Cut-off issue

Sound quality

Call issue

Battery/Charging issue

Quality related issue

Others

1. Ear tips

2. Left earbud

3. Right earbud

4. Volume-up button

5. Multi-function button

6. Volume-down button

7. LED indicator

8. Micro USB charging port

9. Battery

10. Microphone is behind the Volume-up button

Long press the multi-function button for about 2 seconds

Long press the multi-function button for about 3 seconds

Function

To enter pairing mode

Current Status

Power off mode

Operation

LED Indicator Voice Prompt

PairingRed and blue lights

flash alternately

Long press the multi-function button for about 5 seconds Press the multi-function button once

Press the volume-up button once

Press the volume-down button once

Long press the volume-up button for about 2 seconds

Long press the volume-down button for about 2 seconds

Press the multi-function button once

Long press the multi-function button for about 2 seconds

Listening ResponsibilityTo avoid hearing impairment, please make sure to turn down the volume of the music player before connecting the earphones. After putting the earphones into/onto the ears, turn up the volume gradually until to a comfortable listening level. Noise level is measured in de- cibels (db). Exposure to 85db or higher noise will lead to gradual hearing impairment. Please supervise your usage and the hearing impairment is a function of loudness against time. The louder the sound is, the shorter you can be exposed. The softer the sound is, the longer you can listen.

If you want to connect the earphones to another device,

Please fully charge the earphones before the first use.

Warranty Period: 12 Months

Email us to enroll our VIP program and gain an extra half a year warranty.

support@linklike-audio.com

linklike-audio.com

6mm

20~20000Hz

105±3dB

32Ω

Speaker size

Frequency range

Sensitivity

Impedance

Battery capacity

5.0

≤ 33 ft

≈ 3 hrs

≈ 16 hrs

≈ 480 hrs

0℃~45℃

Bluetooth version

Transmission range

Charging time

Music play time/Talk time

Standby time

Working Temperature

Li-Polymer Battery3.7V/250mAh

Fly 9 Neckband Bluetooth Earphones

Lithium Battery Charging Limited

Voltage4.2V

Product name Model Fly 9

Made in China

* Based on the test results of Linklike Lab, for reference only.