Upload
brent-harrell
View
214
Download
0
Embed Size (px)
Citation preview
User Interface – Switch Panel
6 Gang Switch Panel Configuration guide
RS485 Terminal
Fixing hole
Fixing hole
Bayonet
Front View Back View
Subnet ID and Device ID
Remark
MAC Address
Backlit brightness setting
LED indicator brightness of the buttons
Switc
h Pa
nel
Basic information
Switc
h Pa
nel
Key No.
Remark
Switch Mode
Control Target
Function Interface
Input control target No., default is 1, Maximum 99 targets while using Combination Mode
1. Select Mode to open key mode menu
2. Select key control mode
3. Save
Switc
h Pa
nel
Start Programming
Common Key Control Mode
Single On: Run scene on or lights on every time you pressSingle Off: Off Light or scene, every time you press itSingle On/Off: The classical use of toggling of single press ON/OFFMomentary: To run 1 command as momentary pressingCombination ON: To trigger up to 99 different commands every time the button pressedCombination OFF: To OFF up to 99 commands every time the button pressedCombination ON/OFF: To trigger up to 99 commands toggling between ON/OFF each time the button pressed
Switc
h Pa
nel
1. Select Remark
2. Edit remark
3. Save
1. Select Function to
open key function edit
menu
2. Input device address, type and parameter.Example: the control target is a dimmer module(Subnet ID:0, DeviceID:30) channel 1, channel 2 and channel 3 intensity are both 60%, so first select area 1 and set scene 1 60% intensity, then input Subnet ID : 0 Device ID :30 Type : Scene switch parameter 1 : 1, parameter 2 : 1
3. Save
Switc
h Pa
nel
The Button Function of switch panel is listed down:
Invalid: Is to disable the functionScene Switch: Used to trigger the Scene that you create on the Dimmer or Relay AreaSequence Switch: Used To trigger the Sequence that you create on the Dimmer or relay AreaUniversal Switch: Used to send infrared code number, play show control list , set logic flag On or Off, set the hotel door bell services , disable or enable (Motion sensor, light intensity, zone port automation )Single channel Lights: Used to turn one channel lights on./off with special level and running fade timeCurtain Switch: Used to open, close or stop the curtain channelBroadcast scene: Used to trigger same scene number for all the Areas of the dimmer or relayBroadcast Channel: Used to turn ON/OFF or set channel to brightness level for the all channel of Dimmer or relay