Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
Rev
01a
Sheet 1 of 1 Date: 2016-07-11 Doc Nr: MAN A2
CLD1-COE
Unpacking Instructions
Name: JPE
1110
dd-mm-yyyy
11-7-2016
4
5
6
7
8
9
10
A B C D E F G H I J
1
2
3
K L M N
All
rig
hts
are
re
serv
ed
. Re
pro
du
ctio
n in
wh
ole
or
in p
art
isp
roh
ibit
ed
wit
ho
ut
the
wri
tte
n c
on
sen
t o
f th
e c
op
yrig
ht
ow
ne
r. J
PE
dis
cla
ims
an
y lia
bili
ty w
ith
re
ga
rd t
o t
he
acc
ura
cy,c
om
ple
ten
ess
, an
d t
ime
line
ss o
f th
e in
form
ati
on
pro
vid
ed
.
Step 1 : open the box and
carefully remove the inner membrane section that
contains the CLD.
Remove the CLD carefully from
underneath the sheet. Do not cut the membrane sheet!
Step 2 : remove the top Transport PCB by unscrewing
the nuts on top.
Note the fiber underneath this
PCB! So lift the PCB carefully.
Step 3 : remove the bottom
Transport PCB and place the CLD on a flat surface.
Step 4 : remove the 4 threaded bars.
Please take care not to damage the fiber while using
handtools to remove the bars.
Step 5 : (when installing system
in customer setup) unscrew the optical fiber connector from the
feedthrough that is mounted in
the feedthrough PCB.
Remove the feedthrough PCB
from the CLD.
Step 6 : CLD after unpacking.
Note: always use plastic caps to cover fiber outputs and
feedtroughs when not in use.
Unpacking Instructions CLD1-COE. Read these instructions carefully before further unpacking!
Please remove actuator from transport tool only right before mounting in customer setup!
[!] Fiber [!]
Keep transport tool for actuator storage or as quick test tool
(actuator could be operated when mounted in transport tool)