Embed Size (px)
DESCRIPTION
FDA Status Application Methods Repulpable/Recyclable Beverage board Bakery packaging Product Description Coating Weight: Depending on substrate and application the recommended minimum coat weight should be one (1) lb/MSF (Wet). Drying: Sufficient volumes of warm air, and medium or short wave I.R. Load temperatures should range between 95°F and 105°F. Additional curing will continue over time. Product Safety Typical Properties Handling / Storage Stability
Citation preview
ULTERION® 126 BV BASE COATING
Wax-free Excellent base coat for inks, water borne
coatings, as well as UV top coatings* UV fluorescent for easier registration Porosity improvement FDA approved for food contact Product Description Ulterion® 126 BV is specifically formulated for application on paper and paperboard using in-line coater/dampeners flexo presses and flexo/gravure type coaters. It is primarily used as a base coat to seal between ink and functional top coats, such as UV coatings or other Ulterion International products* where drying capabilities are limited.
Typical Properties
Viscosity, seconds (#3 Zahn cup @ 70°F) 15 – 20
pH, Value 7.0 – 9.0 Solids, % 36 – 38 VOC, lb/gal. 0.5 Density, lb/gal. 8.4 – 8.6 Freeze/Thaw Stability One Cycle FDA Status Ulterion® 126 BV is composed of ingredients, which are in compliance with FDA for direct and indirect food contact, (21 CFR 176.170 with limitations, and 176.180 dry film). Application Methods
Application Viscosity: Use as received and stir. Recommended application temperature: 65-75°F. A viscosity reduction with water may be required for certain equipment in order to achieve optimum results. This should only be with Ulterion International’s technical advice.
Repulpable/Recyclable Beverage board Bakery packaging Handling / Storage Stability
The recommended shelf-life is six months when stored at normal (68-75°F) room temperature. Cleaning is best accomplished before coating dries. Use water and liquid detergent. Product Safety When considering the use of Ulterion International products, please refer to the latest Material Safety Data Sheets (MSDS). If you require an MSDS for this product; please call (706) 654-2222 or your Ulterion International Representative.
PERFORMANCE FEATURES MARKET USES
Coating Weight: Depending on substrate and application the recommended minimum coat weight should be one (1) lb/MSF (Wet).
Drying: Sufficient volumes of warm air, and medium or short wave I.R. Load temperatures should range between 95°F and 105°F. Additional curing will continue over time.
