31

Figure 6-1: Side Support Bracket Location Figure 6-2: “U” Shape Bracket Location

• Failure to follow the above removal procedure may cause the user injury or damage the plastic Dust Collecting Pan.

Optional Dust Collecting Assembly, Optional Stand

The Dust Collection Assembly is an optional accessory that is used to help control the dust (when used with the optional dust control kit) developed while dry cutting. The following procedure is required to install the Optional Dust Collecting Assembly:1. Place the Dust Collecting Guard on to the rear of the machine. The inner sides of the Dust Collecting Guard fits inside of the vertical up rights. The bottom of the Dust Collecting Guard has a flange with a rubber gasket glued to it, this flange fits over the outside rear of the water pan.2. Align the holes in the Dust Collecting Guard with those in the machine’s vertical uprights and those in the water pan.3. Attach the one (1) Side Support Bracket to the inside of each side of the Dust Collecting Guard with the hex-head bolts and flat washers (see Figure 6-1: Side Support Bracket Location). NOTE: The Side Support Bracket will hold the Dust Collection Guard to] the vertical upright. This figure is shown in an exploded view for clarity.4. Place the smaller “U” shaped bracket over the inside of the water pan’s rear flange (see Figure 6-2: “U” Shape Bracket Location). NOTE: This figure is shown in an exploded view for clarity.5. Align the holes in the smaller “U” shaped bracket with the holes in the water pan’s rear flange.6. Place one (1) Carriage Bolt into each of the smaller “U” shaped bracket holes.7. Align the larger “U” shaped bracket holes with each of the threads of the Carriage Bolt and attach With the wing nuts.

Side Support Bracket

Small “U” Shaped Bracket

Optional Folding Stand part number 235001

[

Attach the Block Buster Mini to the stand with the wing nuts supplied with the optional stand

32

Optional Dry Cutting Kit

The optional Dry Cutting Kit is used to collect dust when dry cutting. The kit will help to reduce the amount of visible dust in the air when properly installed.

To install the Optional Dry Cutting Kit:1. Disconnect the Power Supply 2. Attach the Dust/Water Collecting Splash Guard Assembly as per the instructions on page 31.3. Attach the Vacuum Hose Adapter to the 4” outlet with the supplied band clamp.4. Attach the Vacuum Hose to the Vacuum Hose Adapter and to the Vacuum.5. To operate the Vacuum refer to the Vacuum Owner’s Manual.

Optional Dry Cutting Kit part number 235004 consist of:Vacuum with HoseVacuum AdapterBand Clamp

NOTES

Norton Construction Products2770 West Washington Street

Stephenville, TX 76401Phone: 800-554-8003 or 254-968-4161

Fax: 800-443-1092