USER GUIDE

TripleFlexEnergy for the hip knee ankle

TM

1

2

3

4

Part

Part

Part

Part

4Part

S4S3

Triple

Flex

TM

Left

4

1

Pelvic Belt

Leg Brace

Leg Brace (Replaces sections 2 - 4)

Knee Cu�

Ankle Cu�

1

OR

OR

PARTS LIST: LEFT SIDE

Inside the shoe foot cu�

Outside the shoe strap

S2 S2

S2

S2

Triple

Flex

TM

Left

4

1.5” Hook VelcroTF2A3L

2Left

TripleFlexTM

Left

1

Pelvic Belt

Leg Brace

Leg Brace (Replaces sections 2 - 4)2

Knee Cu�

Ankle Cu�

1

3

4

OR

OR

Part

Part

Part

Part

4Part

PARTS LIST: RIGHT SIDE

2

Outside the shoe strap

S4S3

TripleFlex TMRight

4

Inside the shoe foot cu�

S2S2

S2

S2

TF4A3R

TripleFlex TMRight

4

1.5” Hook VelcroTF2A3R

2

TF4A3R

TripleFlexTM

Right

1Part

Feed belt through buckle loop and fold back to attach Velcro. Close belt �rmly on pelvis. Belt should not rest in waist area.

Adjust Part 1 so that it aligns with the center of the thigh and knee.

Align Part 2 just below knee.

Wrap Part 1 just below waist.

S3

1

1

STEP 1

STEP 3

1.5” Hook Velcro 1.5” Hook Velcro

STEP 4

1

STEP 2

3

1Part

1Part

2Part

Pelvic Belt

KneeCu�

TF2A3R

2

1Part

Wrap Part 2 around upper calf just below knee.

Align Part 2 and �rmly close velcro strap. IMPORTANT: Make sure the cu� is �rmly held to the leg.

Connect straps from Part 1 to top buckles on Part 2.

1.5” Hook Velcro 1.5” Hook Velcro

STEP 5 STEP 6

STEP 7

4

2Part2Part

2Part

Straps

TF2A3R

2

TF2A3R

2

Align Part 3 with the center of the leg and fasten Velcro® closure.

STEP 9

STEP 10

STEP 8

Wrap Part 3 around the narrowist point below the calf.

Align foot cu� in the arch of the foot. Note that the “4” label should be right side up on top of the foot of the wearer. (See inset.)

Align shoe strap in the arch of the shoe. Note that the “4” label should be right side up on top of the foot of the wearer. (See inset.) 5

OR

2Part 2Part

3Part

3Part

4Part

Foot Cu�

4

4

Part

Shoe Strap

Ankle Cu�

S2S2

S2

S2

TF4A3R

TripleFlex TMRight

4

TopView

S2

S2

S2

S2

TF4A3R

TripleFlex TM

Right

4

Wrap Part 4 around shoe and fasten Velcro® closure. This section should be �rmly wrapped around the shoe.

Wrap Part 4 around foot and fasten Velcro® closure over “R” (or L) label. This section should be �rmly wrapped around the foot.

STEP 11

6

OR

Foot Cu�

Shoe Strap

4Part

4Part1

2

12

Feed straps from part 4 through loops in Part 3

Feed straps from Part 4 through bottom buckles on Part 2

STEP 13

3

4

STEP 12

Place shoe over foot cu�.

STEP 14

Place shoe strap over shoe.7

OR

Feed straps through plastic loops. Trim strap ends. Melt strap ends to prevent fraying

STEP 15

STEP 16

8Elastic will be relaxed while seated. Elastic will become taut when standing.

After Knee Cu� is properly applied, access strap can be trimmed 1” past Hook Velcro

Tighten upper and lower section straps until proper tension is acheived. A properly adjusted TripleFlex will pick up the hip, knee, and foot in the swing phase of gait.

To correct inversion of the foot, tighten the outer elastic strap more than the inner strap.

STEP 18

STEP 17

9

More Tension

Mor

e Te

nsio

n

Less

Tens

ion

Foot Inversion

Less Tension

IncreasedFlexion

6111 Jackson Rd, Suite 200Ann Arbor, Mi 48103

800.552.3539

P/N 0001109 V1.0

WASHING INSTRUCTIONS

Wash TripleFlex by hand in lukewarm soapy water using Ivory Liquid Hand Soap® (or similar mild hand soap). Add just enough soap to produce a soapy bath. Suggested concentration: 1 teaspoon per 1 gallon of water.

Rinse thoroughly by hand using cool or lukewarm water until it is free of soap.

Once washing is complete, roll up in a dry towel and squeeze out excess water.

Remove from the towel and lay �at until completely dry. For faster drying time, place directly in front of a fan.

Do not machine wash or dry.

Never use bleach on TripleFlex.

•

•

•

•

•

•