8/12/2019 Tech Drawing Pre-lim Exam ( draft only)
2/3
9. If you want to get the accurate angle measurement which of
the following should be used?
a. Compassb. Trianglesc. Protractord. Ruler
10. A tool used to draw irregular curve lines?a. Templateb.
Compassc. French curved. Protractor
11. The style of lettering used in technical drawing is:a.
Gothicb. Old Englishc. Blockd. Roman
12. When doing any lettering one must first construct:a.
Vertical linesb. Ellipses
c. Guide linesd. Inclined lines
13. When lettering, the space between words is approximately:a.
The height of the letterb. Two times the height of the letterc.
Three times the height of the letterd. None of the above
14. An edge of a drawing which is hidden is described on a
drawing by using a:a. Solid lineb. Thin linec. Dashed line
d. Straight line
15. A career field in which a person designs buildings, banks,
or homes is called:a. Architectureb. Engineeringc. Draftingd.
Designing
16. A person who draws technical drawings is called a(n):a.
Architectureb. Engineeringc. Draftsmand. Artist
17. Used to draw a circle or arc:a. Templateb. Compassc.
Flexible curved. All of the above
18. You can create horizontal lines with a:a. T-Squareb.
Parallel Rulec. Both A & Bd. Neither A or B
8/12/2019 Tech Drawing Pre-lim Exam ( draft only)
3/3
19. If all the parts of a drawing are seems to be in correct
size when compared to each other, then
the drawing is?
a. Finished c. In Proportion
b. Ruled d. Incorrect
20. bonus
II. READ CAREFULLY THE FOLLOWING INSTRUCTION AND SPECIFICATION
NEEDED.
REMINDER: DO NOT USE BALLPEN FOR SKETCHING, ONLY RULER IS
ALLOWED FOR
MEASUREMENT.
A. Identify and sketch the series of straight lines below ( 2
points each)
1. VISIBLE OBJECT LINE
2. CONSTRUCTION LINE
3. CENTER LINE
4. HIDDEN LINE
5. LONG BREAK LINE
B. Sketch a circle with a radius of 50mm ( 2 points)
C. Sketch an ellipsewith in the rectangle that has a length of
80mm and a width of 40mm ( 2 points)
D. Sketch three single strokevertical uppercase lettersin a grid
lines exclusively for a 6 x 6
units only. ( 6 points)
III. PROVIDE ANSWERS ON THE FOLLOWING, CHOOSE ONLY TWO PROBLEMS.
( 5 points each)1. Name three objects/tools needed to make a
sketch.2. Differentiate Technical drawing to Artistic drawing
3. Differentiate Mechanical drawing to Sketching
4. Name three drafting tools and state the function / usage of
it.
