1
* ) These characteristics are for guidance only and are not to be taken as product specifications. The tolerances are given in the product specification sheet. For further information on product properties, toxicological, ecological and safety data, please refer to the safety data sheet. June 2005 = registered trademark by Clariant Page 1/1 Clariant GmbH Division Functional Chemicals 65926 Frankfurt am Main, Germany Division Functional Chemicals Dispersogen LFS Anionic dispersing agent for pigments and minerals Composition Polyarylalkylphenol polyethylene glycol ether phosphoric acid ester Product properties *) Active substance content about 88 % in water Ionicity anionic Appearance at 25 °C brownish, viscous liquid pH value (DIN EN 1262), 5 % in water at 50 °C approx. 7 Solubility at 25 °C soluble in water Density at 25 °C approx. 1.14 g/cm³ Viscosity (Bohlin, 25°C) about 24.000 mPa*s Flash point (DIN/ISO 2592) > 100 °C Biocides free of any additional biocide Surface properties Critical Micelle Concentration: about 0,01 g/l a.s. Surface tension: about 42 mN/m at 1 g/l a.s. Use Dispersogen LFS is an anionic AP-free dispersing agent and used for water / solvent based pigment prepara- tions. Dispersogen LFS is suitable for inorganic pig- ments, carbon black and specially for organic pigments. The advantages of Dispersogen LFS are - high pigment concentration - low viscosity of the preparation - high stability of the preparation in a wide tempera- ture range - low foaming. General recommendation of dosage: 1 - 6 % on inorganic pigments and fillers 4 - 20 % on organic pigments. This information is based on our present state of knowledge and is intended to provide general notes on our products and their uses. It should not therefore be construed as guaranteeing specific properties of the products described on their suitability for a particular application. Any existing industrial property rights must be observed. The quality of our products is guaranteed under our General Conditions of Sale.

TDS - Dispersogen LFS

Embed Size (px)

Citation preview

Page 1: TDS - Dispersogen LFS

*) These characteristics are for guidance only and are not to be taken as product specifications. The tolerances are given in the product specification

sheet. For further information on product properties, toxicological, ecological and safety data, please refer to the safety data sheet. June 2005

= registered trademark by Clariant Page 1/1

Clariant GmbH Division Functional Chemicals 65926 Frankfurt am Main, Germany

Division Functional Chemicals

Dispersogen LFS

Anionic dispersing agent for pigments and minerals

Composition Polyarylalkylphenol polyethylene glycol ether phosphoric acid ester

Product properties *)

Active substance content

about 88 % in water

Ionicity

anionic

Appearance at 25 °C

brownish, viscous liquid

pH value (DIN EN 1262), 5 % in water at 50 °C

approx. 7

Solubility at 25 °C

soluble in water

Density at 25 °C

approx. 1.14 g/cm³

Viscosity (Bohlin, 25°C)

about 24.000 mPa*s

Flash point (DIN/ISO 2592)

> 100 °C

Biocides

free of any additional biocide

Surface properties

Critical Micelle Concentration: about 0,01 g/l a.s. Surface tension: about 42 mN/m at 1 g/l a.s.

Use Dispersogen LFS is an anionic AP-free dispersing agent and used for water / solvent based pigment prepara-tions. Dispersogen LFS is suitable for inorganic pig-ments, carbon black and specially for organic pigments. The advantages of Dispersogen LFS are - high pigment concentration - low viscosity of the preparation - high stability of the preparation in a wide tempera-

ture range - low foaming.

General recommendation of dosage: 1 - 6 % on inorganic pigments and fillers 4 - 20 % on organic pigments.

This information is based on our present state of knowledge and is intended to provide general notes on our products and their uses. It should not therefore be construed as guaranteeing specific properties of the products described on their suitability for a particular application. Any existing industrial property rights must be observed. The quality of our products is guaranteed under our General Conditions of Sale.