Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
Angle plate
4. Drill holes at the 2 marks using a 3/16” drill bit.
3. Mark the center of the two mounting holes.
6. Install housing with supplied screws. ( DO NOT FULLY TIGHTEN )
1. Drill two 1/8” mounting holes on back of housing.
2. Hold housing at desired mounting location ensuring it is level.
8. Close the sensor casing.7. Ensure housing is level and tighten screws.
Detectionarea
Less than 8”
30 - 44” Sensitive area
7 feet
7-8”
Within 12” from mounting wall
PIR Sensor
Receiver
Touch free
5. Knock in the two plastic anchors.
Holes with plastic anchors
THICK
THIN
7 to 8”
30 to 44”
For hand sticker: 30 to 44” Touch Free
Wave hand hereto open door
Touch Free
Wave hand here
to open door
Angle plate
Thin
Angle PlateAngle Plate
Thick