C:My documents\salesofficeandrew\270173 Toyota Prado.

Revision 1 – 6/04/2010

This is an Uncontrolled document.

270173

L.P. GAS CYLINDER

INSTALLATION INSTRUCTIONS

TOYOTA LANDCRUISER PRADO

2003 & 2010 Models

This Automotive LP Gas cylinder must be installed in the vehicle in strict accordance with the latest

requirements of AS/NZS1425. Any modifications to the cylinder will render the warranty null and void.

General Cylinder Specifications:

DIAMETER : 375mm LENGTH : 847mm

WATER CAPACITY: 84L L.P GAS CAPACITY : 67L

VALVE ORIENTATION : 90 degrees

Installation:

1. This cylinder is designed to be mounted 2. Remove the rear secondary fuel tank

underneath the vehicle behind the rear from the vehicle.

differential.

3. Loosely fix the right hand attachment bracket 4. Jack the cylinder up into position ensuring the

as shown above to the right hand cylinder bracket. right bracket is positioned on the inner side

Loosely fix the left hand bracket. of the chassis and the left is on the outer side of the

chassis. Move the cylinder as close to the differential

as possible ensuring clearance.

C:My documents\salesofficeandrew\270173 Toyota Prado.

Revision 1 – 6/04/2010

This is an Uncontrolled document.

6. Mark the holes on the chassis with a marker 7. Re-drill the holes on the inside face of the

and lower the cylinder. Drill the holes through chassis to a 18mm dia to accommodate the

the chassis using a 13mm dia drill. crush tube.

8. Bolt the left attachment bracket to the chassis 9. Bolt the right attachment bracket and exhaust using the bolts, backing plates and crush heat shield to the chassis using bolts & backing

tubes supplied. plates supplied, ensuring a crush tube is fitted

within the chassis.

9. Bolt the cylinder to the vehicle, connect and

test in accordance with AS1425.