Take Up Lever Gray

Take Up Lever Gray

Revision Date / Version: 3/18/2014 - 2

Installation Directions for the Take Up Lever “Gray”

Tools Needed.

Phillips Screw Driver

Flat Head Screw Driver (#1)

2.5mm L Shape allen wrench

Part #: 07005BM-B003

Take Up Lever Gray


Installation Directions for the Take Up Lever “Gray”

Remove the 2.0mm set screws and get the Thread Guide (M) off the Needle Case Cover.

Remove the Needle Case Cover.

Loosen the Phillips screws from the side of

the Needle Case Cover.

Thread Guide (M) Needle Case Cover

2.mm Set Screws

Take Up Lever Gray


Remove the 2.5mm set screws from the Left and Right side of the Needle Case as shown above.

To remove the set screws from the Right side make sure the last needle to the left of the Needle Case

Is above the Needle plate and to remove the set screws from the left side of the Needle Case make

Sure the first needle to the Right is above the Needle Plate.

2.5mm set screw from

the Right side of the

head

2.5mm set screw from the

Right side of the head

2.5mm set screw from the

Left side of the head

2.5mm set screw from

the Left side of the head

Take Up Lever Gray


Push the shaft from the Right side of the Needle Case towards the left until the Take Up Lever

That needs to be replace is out from the shaft. Look at the pictures below.

Right side of the Neelde Case Left side of the Neelde Case

Right side of the Neelde Case Left side of the Neelde Case

Take Up Lever Gray


After the Take Up Lever is in place and aligned with the shaft , start pushing the shaft from the left side

Of the Needle Case towards the Right until the shaft is flush with the wall of the Needle Case.

Fig 1

Fig 2

Replace with a new Take Up Lever as shown on fig 2

Remove the broken Take Up Lever as shown on fig 1

Shaf

t

Take Up Lever Gray


After the shaft is back in place proceed to tighten the 2.5mm set screws to secure the Shaft.

Mount the Needle Case Cover and the Thread Guide (M) back on to finish the Job.

Documents

Take Up Lever Gray