Issue DateINSTALLATION

INSTRUCTIONS

Accessory Application Publication No.

Honda Dealer: Please give a copy of these instructions to your customer.

© 2013 American Honda Motor Co., Inc - All Rights Reserved. 0SR95-HL3-211B 1 of 5

PARTS LIST

(1) (2) (3)

No. Description Qty

(1) Fabric rear panel 1

(2) Stay-put 2

(3) Rivet 2

TOOLS REQUIREDPower drill

3/16 inch drill bit

Rivet tool

Awl

TORQUE VALUESNot Applicable

USE AND CARE INFORMATIONCompletely read and understand the instructions • before installing this accessory.

Do not tow the vehicle on an open trailer with • this accessory installed, as the accessory is not designed for use at highway speeds.

To clean, sponge with mild soap and cold water, • rinse with hose and allow it to drip-dry.

Do not machine wash or dry.•

Use mild detergent to remove stubborn stains.•

NOTICEThis accessory will create the need for more frequent • air cleaner maintenance. Service the air cleaner daily when operating in dusty conditions.

FABRIC REAR PANEL (4P)P/N 0SR95-HL3-211B

SXS700M4

MII 14607

September 2013

INSTALLATIONInstall the rear panel over the rear upper cab frame 1. and zip it together around the cab frame cross bar as shown.

ZIPPER

CAB FRAME CROSS BAR

© 2013 American Honda Motor Co., Inc - All Rights Reserved.2 of 5 0SR95-HL3-211B

Route the top strap around the cab frame and attach 2. it to the hook and loop as shown.

HOOK & LOOP

STRAP

Release the SR buckles and loop the straps around 3. the lower frame as shown.

LOWER FRAMER FRAME

STRAP

Attach SR buckles and tighten both sides equally so 4. that the rear panel is centered on the cab frame.

LOWER FRAME FRAME

STRAPAP

Cut out the drilling templates from Page 6 and tape 5. them to the tailgate as shown.

TEMPLATE

SR BUCKLE

<Right side shown>

© 2013 American Honda Motor Co., Inc - All Rights Reserved. 3 of 50SR95-HL3-211B

Make drill marks on the tailgate by pushing an 6. awl through the “X” mark in the drilling templates. Remove the drilling templates.

MARKRRRRRRRK

Drill holes through the marked points with a 3/16 7. inch drill bit.

Insert a rivet through each stay-put as shown and 8. attach them to the tailgate at the drilled holes with a rivet tool.

Stretch the bungees around the stay-puts as shown.9.

STAY-PUT BUNGEE

STAY-PUT RIVET

© 2013 American Honda Motor Co., Inc - All Rights Reserved.4 of 5 0SR95-HL3-211B

THIS PAGE LEFT BLANK INTENTIONALLY

© 2013 American Honda Motor Co., Inc - All Rights Reserved. 5 of 50SR95-HL3-211B

SXS700M4

STAY-PUTTEMPLATE

RIGHT

SXS700M4

STAY- PUTTEMPLATE

LEFT

SCALE

SC

AL

E

NOTICE

If you print this template from your local computer, make sure the printer settings do not “scale” or “shrink” the page.