Upload
velorution
View
455
Download
0
Embed Size (px)
Citation preview
Assembly guide for VANMOOF solar lights
NOTE: assembly procedure for the front and rear light is exactly the same.
1 of 8
Required components
4 x washer 2 x screw 2 x solar light 2 x rubber ring
2x4x 2x 2x
2 of 8
1. Check if the light switch works correctly. Pressed once it lights up continuously, pressed again it flashes, pressed once more it will turn off.
NOTE Make sure the switch makes a distinctive “click”-sound when pressed. If you do not clearly hear a clicking sound do not assemble the light.
NOTE The light has a sensor that makes sure the light can only be turned on when dark. When you check if the light is working properly use your hand to shield the sensor in front of the light.
3 of 8
light works because sensor is shielded by handfrom direct light
light does not work because it is in direct light
TOPVIEW
2. Position the lights with the USB connector positioned downward.
At the front this will mean the button is on the left. At the rear this will mean the button is on the right
1. Check if the light switch works correctly. Pressed once it lights up continuously, pressed again it flashes, pressed once more it will turn off.
NOTE Make sure the switch makes a distinctive “click”-sound when pressed. If you do not clearly hear a clicking sound do not assemble the light.
NOTE The light has a sensor that makes sure the light can only be turned on when dark. When you check if the light is working properly use your hand to shield the sensor in front of the light.
riding direction
FRONT
REAR
4 of 8
3. Make sure the rubber seal at (A) is pressed tightly in between the rear cap and the transparent casing. This is to minimize the resistance from the rubber seal with the tube.
A
avoid the rubber ring being stretched between the tube and the frame
5 of 8
4. Push the light gently into the tube.
B
C
press the button slightly, so it will fit better.
6 of 8
5. When the light is completely inserted, check whether the screw hole is concentric with the hole in the frame (D). If not. try removing the black rubber ring (B) for a better fit When in position, check if the switch still functions properly. If so place the washer in the hole and tighten the screw (C). Check the switch again. Make sure the switch makes a clicking sound when pressed.
B
C
D
7 of 8
correct wrong
NOTE Please make sure the switch and the screw are both in the middle of the hole
if this happens, add an extra washer to makesure the screw is fixed in the hole
8 of 8