Procedure to add Network Adaptor to supervise ISA Board
:locally
Adapter creation
1. Open Control Panel 2. Choose Add Hardware
2 Card supervision
Step 2: Adapter creation [cont.]
5. Click Next
4. Select Yes, I have ...3. Click Next
2 Card supervision
Step 2: Adapter creation [cont.]
8. Select Install the hardware ... 6. Select Add a new hardware
device 7. Click Next 9. Click Next
2 Card supervision
Step 2: Adapter creation [cont.]12. Click Have Disk
11. Click Next
10. Select Network adapters
2 Card supervision
Step 2: Adapter creation [cont.]14. Browse up to
WINDOWS\system32\drivers\LLmanNIC
13. Click Browse
15. Select netLLman.inf
16. Do Open 17. Click OK
2 Card supervision
Step 2: Adapter creation [cont.]
19. Click Next 18. Click Next
2 Card supervision
Step 2: Adapter creation
20. Do Continue Anyway
21. Click Finish
2 Card supervision
Step 3: adapter IP address [cont.]1. In Control Panel double
click Network Connections
2. Select the Local Area Connection that belongs to the adapter
and open its Properties
2 Card supervision
Step 3: adapter IP address [cont.]3. Keep flagged just Internet
Protocol
4. Select Internet Protocol and click Properties
5. Write the IP address and mask for the adapter
2 Card supervision
Step 3: adapter IP addressIP address and mask of the adapter
Point-To-Point address of the connected OMSN
(Point-To-Point address) AND (adapters mask)
2 Card supervision
Step 4: Supervision [cont.]1. Select a supervised OMSN 2. Choose
Realign ISA board population
3. The ISA boards configured in the OMSN are displayed
4. Start supervision
2 Card supervision
Step 4: Supervision [cont.]1. Show equipment 2. ADMIN ADMIN
3.
4. For ES4 board, choose the working mode
2 Card supervision
Step 4: SupervisionETH-USM in case of ES4 board MII mode
