Upload
others
View
7
Download
0
Embed Size (px)
Citation preview
SULO MANUAL HANDLING EQUIPMENT
Stack Trolley for 2 wheel bins The SULO bin trolley is designed to assist in the safe manual handling of Mobile Garbage Bins (MGBs). It enables a stack of MGBs to be safely tilted and manually relocated around the workplace. An MGB stack can also be tilted and moved into a horizontal position where additional work such as the affixing of lids to MGBs can be carried out.
The bin trolley is suitable for use with 80, 120, 140, 240 and 360 Litre MGBs and is fitted with heavy duty industrial castors for maximum user safety. The front castors are fixed and the rear castors are swivel type with brakes. The product bears an engineering compliance plate detailing the individual product’s design and compliance to AS/NZS 1170.0:2002 Structural design actions -General principles.
1200mm 550mm
95
0m
m
40
0mm
1200mm 550mm
95
0m
m
40
0mm
1200mm 550mm
95
0m
m
40
0mm
PRODUCT SPECIFICATIONS
Safe Working Load (SWL): 150kg
Unit weight: 35kg
Rated castors load: 150kg
Finish: Galvanised steel
644mm
1310mm
68
0
QTY kg
© 2012 Subject to technical amendments.
SULO MGB Australia Pty Ltd123 Wisemans Ferry RoadSomersby NSW 2250AustraliaTel: +61 (0) 2 - 4348 8188Fax: +61 (0) 2 - 4348 8128
SULO – Queensland Office11 Argon StreetSumner Park QLD 4074AustraliaTel: +61 (0) 7 - 3725 5000Fax: +61 (0) 7 - 3725 5099
SULO – Victorian Office1950 Hume HwyCampbellfield VIC 3061AustraliaTel: +61 (0) 3 - 9357 7320Fax: +61 (0) 3 - 9357 7340
SULO Talbot - New ZealandGate 4, 13 Kenwyn AvenueEast Tamaki, Auckland 2141New ZealandTel: +64 9 - 968 2180Fax: +64 9 - 968 [email protected]
www.sulo.com.au [email protected]
Tel: 1300 364 388 • [email protected] • www.sulo.com.au
Basic Operating Procedure
Stack Trolley for 2 wheel bins
SAFETY FIRST• Always ensure work area is clean and safe at all times.• Always wear steel cap boots, gloves, hearing, or other protective equipment as required. • Always use correct manual handling techniques.
For more information contact:
Obtain Trolley 1. Obtain stack trolley and adjust front fork to a height that fits just
under the rim of the bin on the bottom of the bin stack. Adjust height of handle to the same height as fork.
2. Remove the plastic sleeve from the stack if applicable.
Check for water 3. Check top bin of stack does not contain water. (Use step ladder if
required to empty water from top bin)
Lift stack 4. Apply brakes to rear wheels
5. Raise the rear wheels of the trolley and position the forks of the stack trolley up and under the front rim of the bottom bin in the stack.
Notes: • Ensure thevertical ribsof thebinarebetween the forkson the
stacktrolleytopreventthestackfallingover.
• Ensuretrolleyisonlevelgroundbeforeliftingstack.
Lower trolley 6. Slowly and carefully lower the rear wheels of the stack trolley to the
ground.
Notes: • Placeonehandon thestack forsupportduring the lowering to
preventthestackcomingallthewaydownprematurely.
Basic Operating Procedure
Stack Trolley for 2 wheel bins
Tel: 1300 364 388 • [email protected] • www.sulo.com.auFor more information contact:
Lower stack 7. Slowly and carefully lower the stack of bins onto the two
supports of the stack trolley. Note: • Alwaysstandtowardssideofstackwhenlowering
Work continues 8. The stack of bins can now be separated, moved, or otherwise
worked upon with a reduced risk of personal injury. Note: • Applythebrakesontherearwheelswheneverthetrolleyis
stationary • Ifnecessary,usebinseparatortoslidebinsapart.
Half-way 9. If separating bin stacks, once the stack has been reduced past
the first supporting upright of the trolley, the stack should be removed from the trolley by reversing steps 4, 5, 6 and 7, and lowered manually to the ground for separation.
MAINTENANCE PRE CHECKS Youmustcheckthat:The stack trolley is in good working order, i.e. No broken welds, no bent supports, wheels ok, no significant rust etc.
IMPORTANT POINTS • Always ensure trolley is on level ground before lifting or lowering a stack of bins
• Always apply the brakes to the rear wheels whenever the trolley is stationary
• Always ensure that bins are empty before lifting or lowering a stack of bins with the trolley
• Position the stack trolley securely under the front rim of the bottom bin in the stack, before lowering the stack onto the trolley.
• Always stand clear of bin stacks that have water in them or have the potential to fall forward.
CHANGES AND SUGGESTIONSIf you have any suggestions to improve this document please email your suggestion to [email protected]
SU
LO S
T 01
/12