Upload
osma
View
48
Download
5
Tags:
Embed Size (px)
DESCRIPTION
Stringing Manual Part 4: Shooting Strings. One way to string a stick By Devin Clifford 11/08. Shooting String tools. What and how many strings you want is up to you. I like the nylon up top with two straight hockey laces and a hockey lace “V” string below. Nylon across the top. - PowerPoint PPT Presentation
Citation preview
Stringing ManualPart 4: Shooting Strings
One way to string a stickBy Devin Clifford
11/08
Shooting String tools
• What and how many strings you want is up to you.
• I like the nylon up top with two straight hockey laces and a hockey lace “V” string below.
Nylon across the top
• Use the 9 diamond row under the locked in top string.
• Loop the string front to back and back to front across the row.
• Loop around the sidewall string, but not around the plastic of the head.
Beginning looks like this
Looping back around
• Loop the shooting string around the sidewall – not the plastic.
• Go put it back through the same hole under the shooting string.
• Put it through the next hole in the mesh, over the string this time.
• Continue this alternating pattern.
Finishing the Nylon
• Make sure the shooting string hits every hole across 1 single row of mesh.
• Tie the string ends to each other tightly.
• Again, not around the plastic at all.
Another way to do it
• You can weave the shooting string across a row hole by hole.
• Start by looping the string outside the mesh around the sidewall string.
• Put one end front to back and the other back to front through the same hole.
Weaving …
• Continue this pattern hole by hole across the row.
• The string that goes back to front is always on top, and the string front to back is always on bottom (or vice versa).
Finishing off the shooters
• The “V” String is done just like the other shooters – keep it symmetrical.
• Knot the laces so they will stay their lengtho Do not over-tighten the
knots.• Clean up the ends by
cutting a burning.