Stepping motors

Jari Kostamo

Outline

• Introduction• Stepping motor structures• Properties of stepping motor• Control of stepping motors

Stepping motor

• Stepping motor is an electromechanical device which converts electrical pulses to discrete mechanical translation.

• Axle of the stepping motor turns in discrete steps when the coils are pulsed with electric current in proper sequence

• Direction of rotation depends on the sequence of the pulses

• Angle of rotation is determined by the number of pulses • Rotation speed is determined by the frequency of the

pulses

Stepping motor

• Typically for small power applications (holding torque in a range of 1 – 1000 Ncm or power less than 750 W)

• Low cost• Easy to interface with digital control with microcontrollers. • Precise control without feedback (step angle as low as 0,5o)• Can be used with feedback• Stepping rated possible up to 40 kHz (drive) or 3 kHz (pull in freq)• Dynamical properties are only moderate due to the operating principle• Can lose steps when loaded heavily • Operating range may contain problematic areas• Achieved position is not perfectly precise but the motor can be displaced

with a small torque. • Operating is slightly shaking• Audible noise due to the stepping

Stepping motors

• Typically 12, 24, 72, 100, 144, 180 or 200 steps per revolution (equal to 30, 15, 5, 3.6, 2.5, 2 or 1.8 degree step angle).

• With microstepping even 10000 steps per revolution can be achieved.

• Unipolar and bipolar motors.• Open control is used if losing steps

does not cause critical problems.

Magnetic circuit

• Translation in stepping motor is produced by magnetic forces

• Magnetic circuit is generated with coils

• Magnetic field strength depends on the nuber of ampere turns, current and geometry

• Inductance of the coil creates an opposing voltage proportional to the rate of change in current.

– Inductance has a tendency to limit the chages in current.

• Larger voltages are needed if rapid changes are desired.

Current control

Pulse width modulated control (PWM)

• Efficient and modern way to control currents of the motor coils is PWM– PWM amplifier, chopper, switched

mode amplifier...

• Transistors are rapidly switched on and off

• ON-state has low resistance – OFF state has high resistance – Yields to small losses

• Current is defined by the proportion of the ON and OFF states

• Can be implemented with uC

• Dedicated circuits available.

Permanent magnet motor Reluctance motor Hybrid motor

Stepping motors

Kenjo, T., Stepping motors and their microprocessor controls

Variable reluctance stepping motor; VR motor

Kenjo, T., Stepping motors and their microprocessor controls

Permanent magnet stepping motor; PM motor

Kenjo, T., Stepping motors and their microprocessor controls

Hybrid stepping motor

Linear stepping motor

2D stage: Baldor

Parker

• Functional principle similar to hybrid motor,

2D motions possible

(Kirjasta Bolton, Mechatronics)

Full stepping

Half stepping

A1 A2 B1 B2

A1 A2 B1 B2

Stepping motor control example

Half stepping

(Book: Fraser & Milne, Integrated Electrical and Electronic Engineering)

Kenjo, T., Stepping motors and their micro-processor controls

Dynamical properties of stepping motors

Kenjo, T., Stepping motors and their micro-processor controls

Holding torque

Kenjo, T., Stepping motors and their micro-processor controls

“If vibration at low speeds is an issue, consider the geared types. Not only does changing gears increase torque, but also these models improve starting and stopping responsiveness.”

Settling time

Lawrence & Mauch, Real-TimeMicrocomputer System Design

Speed-torque graph

Resonance frequencies

Typical stepping profile

Stepping rate

Direct computer

control

Computer control withintelligent indexer

Computer control with stepping circuit

Lawrence & Mauch, Real-TimeMicrocomputer System Design

Control systems for stepping motors

Digital linear actuator