Static sink.pdf

8/14/2019 Static sink.pdf

1/5

titled

p://www.subtleenergies.com/ormus/research/stattrap.htm[14/01/2010 8:34:08 AM]

Water System Static Trap

Sam wrote:

About five years ago, I was irrigating a field with aluminum sprinkler pipe and well water. After irrigating the field for about two months, I noticed

a clear, jelly-like substance forming at the end of the last sprinkler pipe. I didn't know what the material was, but when I put my finger in it, it tasted sweet.

I have thought up a trap design based on Sam's observations. I understand that his sprinkler pipes were

configured somewhat like this:

_____________|_____________________________|_________________________________________|______________________/_______|

This "drawing" represents two sections of pipe the upright lines in the center top of each section of piperepresents the sprinkler stand pipes which the sprinklers are attached to. The slash mark toward the end

of the right pipe would represent the boundary between ordinary water and the m-state water.

Since there is a dead space at the end of the right pipe section where water does not flow this would

provide a comfy space for the ORMUS elements to collect. They seem to like aluminum in the first place

and they like to remain stationary in relation to magnetic fields. This dead space at the end would fill both

of those requirements. The alternative route for them to travel is out through a spinning sprinkler head.

This arrangement fills all of the requirements of a magnetic trap.

Static Trap DesignMy trap design has water coming into a cross tee and leaving one leg of the cross tee through a plastic

pipe which has a spiral of magnetic tape wound around it. The other two legs of the cross tee lead to atwo foot long, large diameter section of pipe with a valve near the tee and a drain plug at the other end.

This configuration looks like this:


2/5

titled


When this device is installed it will be horizontal.

The water main will enter from the upper right and exit to the upper left.


3/5

titled


The exit pipe is spiral wrapped with magnetic tape for about nineteen inches of length.

The two large pipes are the accumulators.


4/5

titled


There are valves between them and the cross shaped manifold.

The m-state should collect in the large sections of pipe.

These sections can be drained by closing the valve and opening the drain plugs in the ends of the large

diameter pipe.

The large sections of pipe can be opened up so that I can experiment with different fill materials.

Jim says that acrylic sweaters will absorb and hold the m-state polywater quite well. He also claims that

these elements have an affinity for aluminum as does David Hudson. Being able to open up the large pipe

would allow me to try the trap for a while with an aluminum lining and without or with and without it being

stuffed with an acrylic sweater.


5/5

titled

// b l i / / h/ h [14/01/2010 8 34 08 AM]

Cross Tee and adaptor detail.

PARTS LIST

Item Number

1/2" PVC Valve 2

3/4" PVC Cross 1

3/4" PVC to 1/2 thread adapter 3

1/2" PVC Close pipe nipple 2

2" PVC to 1/2" thread adapter 42" PVC to 2" female thread 2

2" PVC to 2" male thread 2

2" PVC coupler 2

1/2" PVC plug 2

3/4" pipe elbow 1

3/4" PVC Valve 1

4 feet of 2" PVC pipe

Documents

Static sink.pdf