ST 1060 - ST 1073Mobile column lifts

capacities 13,000 - 16,000 lbs

ST 1073-FCFST 1060-FCFST 1073-FSFST 1060-FSF

Rapid lifting and loweringThe total lifting height of 69” is reached

in just 70 seconds for all the ST 1060

models and 80 seconds for all ST 1073

models. Stertil-Koni mobile lifts are

amongst the fastest in the world.

ReliableThe hydraulic lift system works fast,

trouble-free and is tested with 50,000

cycles at maximum load. Even in the

case of a power supply failure, it is

possible to lower the columns manually.

Super single drive axle tiresThe length of the pick-up forks is

14 inches as standard, therefore the

Stertil-Koni ST 1060’s are capable

of handling the recently introduced

super single drive axle tires,

in accordance with the tire

manufacturer’s

recommendations.

Easily MoveableThanks to the hydraulic pallet

truck mechanism, combined with

our patented gas shocks, we offer you

the best possible automatic overload

protection. The unique Stertil-Koni

design enables one person to move the

column very easily.

Independent Safety Mechanical: The patented, mechanical

locking system works fully independent

of the lifting system and is always

active. Gravity activated locks

guarantee the highest safety.

Hydraulic: Every lifting cylinder is

equipped with flow controlled check

valves, which are active during the

complete range of travel. By means of

our standard integrated pressure relief

valves, each individual column is

protected against overloading.

Superior engineering The ST 1060 and ST 1073 hydraulic

mobile column lifts have a lifting

capacity of 13,000 lbs and 16,000 lbs

per column respectively. The total

lifting capacity can be increased by

adding more columns to the system

up to a maximum of 28 columns. No

adaptation of the column is needed

to do this: just plug in the extra

columns and off you go!

Conventional controls allow the

operation of a set consisting of max.

4 columns with individual, paired

or group operation.

Superior controls allow the operation

of a set consisting of 2 columns up to

28 columns with individual, paired or

group operation.

Unique synchronization systemThis ensures a smooth lifting & lowering

cycle, even in the event of an extremely

uneven load distribution of the vehicle.

Selectable lowering Lowering speed selector

switch for normal or

slow descent of the

vehicle (patent pending).

The name Stertil-Koni is

synonymous with

innovation, safety, quality

and reliability. We have

become the world’s largest

manufacturer and supplier

of hydraulic mobile column

lifts. This has been achieved

by offering top quality

products and excellent

service that satisfy the end

users during the long life span

of our products.

Active WorldwideStertil-Koni is the world market

leader in the supply of mobile

column lifts which are used by

reputable companies in the

following industries: truck, bus,

waste management, aviation,

mining as well as special

applications.

We have our own sales

organizations in the Netherlands,

U.S., Germany, U.K., France and

Poland and work with over 50

exclusive partners world wide.

There is always a Stertil-Koni

dealer near you!

Safety, quality, reliability and

service are the key words for the

modern workshop. Therefore,

Stertil-Koni products are built

around these criteria.

Our products comply with the most

stringent safety regulations world

wide and pave the way for efficient

and flexible garage management

with the best possible price

performance ratio.

Stertil-Koni: your Heavy Duty Lifting Partner

Model ST 1060

Control systems

Superior control system (FSF models)l According to the EN 954-1 Cat. 2

and future EN ISO 13849-1

directives.

l Up to 28 columns can be connected

in one set-up.

l Integrated phase check controls.

l User-friendly operation through

selector button on every column for

individual, paired and synchronized

operation.

l Programmable features e.g.

maximum height setting.

l Slow lowering function through

selector switch (patent pending).

l Numerical on-board diagnostics.

l NEMA 4 / IP 65 splash proof design.

l Operational voltage 24V/DC.

The following models can be identified:

Conventional control system (FCF models)l System operation, including

individual and paired, from the

primary column.

l Integrated phase check controls

l User-friendly operation through

selector button on control cabinet.

l Programmable features e.g. maximum

height setting.

l Maximum 4 columns can be

connected.

l Standard cables, hard wired on the

secondary columns, with free entry

lay out.

l Numerical on-board diagnostics.

l NEMA 4 / IP 65 splash proof design.

l Operational voltage 24V/DC.

Superior and Conventional control systemsStertil-Koni offers two different control systems: the Superior and Conventional control system. In the overview below,

the most important features and characteristics of both control systems are clearly explained.Lifetime guarantee The patented, synthetic runner wheel

system is self-lubricating and therefore

does not require any maintenance.

This runner wheel system comes with

a lifetime guarantee.

Highest safety standards• Independent mechanical locking

system.

• Carriage safety ladder increments

of just 1 1/4”.

• Automatic overload protection.

• The lifting system is subjected

to 50,000 full load lifting tests.

ClearanceThe clearance between the column and

the vehicle is 9” (ST 1060 models), or

7” (ST 1073 models), therefore avoiding

the columns contacting the vehicle’s

side in the case of a flat tire or air

suspension failure.

Superior control system

Conventional control system

lSuperior control system with a control cabinet on each individual column.

Slow lowering selector switch for slow and normal descent speed of the vehicle (patent pending).

Hydraulic pallet jack equipped with patented automatic overload protection. For easy moving and relocation of the column.

Fixed forks length of 14 inches suitable for handling super single drive axle tires.

Conventional control system with one master control cabinet in a set of maximum 4 columns. l

l

l l

l l l l

l l

l

Synthetic fixed front wheels to reduce floor surface pressure (especially compared to steel wheels). l l l l

IN

NO

VA

TI

ON

Wheel adaptersIn case it is required to lift vehicles with

small wheels, reducer sleeves are

available. Vehicles with wheel diameters

R12-R15 require two wheel adapters.

One wheel adapter is sufficient for

wheel diameters R15-R17.

Drive over connection cablesThese sturdy connection cables are

provided with a steel interior sheathing.

They can cope with the wheel pressure

of trucks and buses without any

problem. (Only available in combination

with the superior control system)

Base frame extensionsBase frame extensions in combination

with fork extensions (20” long) to lift

recreational vehicles with in-set wheels.

Remote controlAn optional remote control will allow the

operator to control the system from the

Options

FL

EX

IB

LE

optimum location. The remote control,

with up and down buttons, is also

equipped with an emergency stop and

is supplied with 33 feet of cable.

Forklift adaptersThe combination of 2 mobile column

lifts with special tracks (drive-on height

only 5”) allows a forklift to be lifted

safely.

Traverse beamsDifferent chassis contact cross beams

are available;

- For wheel-free lifting of trailers.

- For lifting the trailer at the king-pin

coupling.

- For lifting extremely low vehicles e.g.

low floor buses.

- Special versions on request.

LightingLighting, consisting of two IP 67 rated

36W tube lights, is a unique option

available on Stertil-Koni Mobile Column

Lifts. When fitted this ensures that the

underside of the vehicle is effectively

illuminated. (Only available in

combination with superior control

system)

Drive over connection cable

Remote control

Specifications ST 1060, ST 1073Lifting capacity: ST 1060, 13,000 lbs,

ST 1073, 16,000 lbs

Lifting system: hydraulic lifting system with

microprocessor controlled tracking/

synchronization system

Lifting height: 69“

Lifting time: ST 1060, 70 seconds,

ST 1073, 80 seconds

Motor power: 3 hp per column

Weight: 1100 lbs per column

Column height: 102”

Maximum safety:- ANSI/ALI-ALCTV 2007 certified (United States of

America)

- CSA certified (Canada)

- CE certified (Europe)

- Low voltage control cabinet

- Automatic overload protection

- Independent mechanical locking system

- Microprocessor-controlled tracking system

- Automatic stop when highest position is reached

- Dead-man’s operation

- Emergency switch on every control box

- Splash-proof electrical system (NEMA 4 / IP65)

More information?For more or specific information about the ST 1060,

ST 1073 or one of the other quality products from

Stertil-Koni, please contact us for further assistance.10

60-1

0730

407.

US

/ S

tert

il is

a r

egis

tere

d t

rad

emar

k o

f S

tert

il B

.V..

We

rese

rve

the

rig

ht t

o m

ake

chan

ges

in s

pec

ifica

tio

ns w

itho

ut n

oti

ce a

nd w

itho

ut m

akin

g c

hang

es r

etro

acti

ve.

Stertil-Koni U.S.A. Inc., 200 Log Canoe Circle, Stevensville, Maryland 21666

Tel. 410-643-9001 Toll free 800-336-6637 Fax 410-643-8901 www.stertil-koni.com E-mail: lifts@stertil-koni.com

* Technical specifications are available at: www.stertil-koni.com

FL

EX

IB

LE

ST 1060

ST 1073