SPA 413 Instructions

8/13/2019 SPA 413 Instructions

http://slidepdf.com/reader/full/spa-413-instructions 1/15

HOT TUB

Model SPA-413

OPERATING INSTRUCTION



1. I Illustration to buttons

Fig.1 Control Panel

“ MI N ”Frequency up- searching /Setting/Minute

“

” On-off/Setting confirm



7 Menoery preser4e once power off

: Fahrenheit ; Centigrade degree switch&5 <ntifree2ing functions&& .eys with +ac$light&' #oc$ settingl&1 (hree-phase or single-phase0 a4aila+le of &&5-&'5!<C or ''5-'35!<C&3 Choice with offering a <C for circumscri+ing ! or (!&6 Choice with power control& Choice with gal4anoscope de4ice

III Operation

Fig*1 (emperature )ormal isplay Fig*3 Senor on/short circuit display

1 hen you first start the spa0 the +ac$light will +e dimmed and the #C will show the current timeand temperature* =f there is a pro+lem with the circuit +oard the controller will display the code>?&@* hen the radio frequency is displayed as >---@ it indicates that the spa is in >power off@model0 and pre-heating and circulation cleaning function is off*



circulation is in action or not* See following Fig 6-

AM

AM

Fig .5 Circulation-cleaning off Fig .6 Circulation-cleaning on

hen setting the Circulation-cleaning the display must +e in the >Power off@ status and the #C display >---@

1 Press “ ” to enter Circulation-cleaning setting mode and the #C showes and flashes “

”,and then the circulation wor$es on *Press “ ” again to off the circulation cleaning0and the “ ” will

disappear*

2) Press “ ” mi !tes a "“ ” hours to ad9ust the time*

=t will add & minute when pressing “ MI N ” each time and the minutes could +e added the continually

h i th “

MI N” ith t t i * (h d9 t t i 5 6 *



2

Set start of circulation

3 Set lasting time for circulation

4

Finished

3) Press “ ” to set the circulation timesD it will show the minimumA6 minutesB on the #C and this time will

not flash* =t will add 6 minutes +y pressing “ ” each time* =t will add & hour +y pressing “ ”each



ON

OFF

Fig % Pre-heat On Fig & Pre-heat Off Pre-heating is set when the spa is in the >Power off@ status and the #C display shows >---@

1 Set pre!eating

2 Time setting "or $re!eating



1 Press “” and enter Pre-heating setting mode0 and the #C flashes of >O)@ ,'ress“ ” can turn

on the pre-heating setting and pressing “ ”agai 0 will turn off the pre-heating* >O)/OFF@ on #C will

show >O)@ and will not flash* Press “ ” to turn off pre-heating* (he #C will show >OFF@ without

flashing* hen the system enters into pre-heating mode0 the setting time will flash on the #C Athis time is

the pre-heating timeB at this moment0 only “ MI N ”a " “

HOUR ” are a4aila+le to change the time

'B =t will add & hour when pressing “

HOUR ” each time and hours could +e added continually when pressing

the “

HOUR ” without stopping* (he ad9ustment of hours is 5-'1

=t will add & minute when pressing “

MI N ” each time and minutes could +e added continually when

pressing the “

MI N ” without stopping* (he ad9ustment range is 5 6:

<fter time setting of pre-heating0 proceed to the ne,t step*

3 P “

VOL+ ” h i l f h i * ill h h i i i i i &5 i *



hen the preheating time is as same as the current time0 the #C screen shows >on@ and the tu+ is alsofilled with water* (he heater will start to wor$* (he heater0 circulation pupm and time counting wor$atsimultaneity* (he countdown time will +e shown on the #C screen0 till the preset time is finished*

uring the preheating0 (he preheating will +e turned off automatically once the preset time is finished*

Or Pressing the “ ”or“ON/OFF

”$ey can stop preheating .

***Notice*** 7!en setting temperature is lo%er t!an or e,ual %it! %ater

temperature )8en t!e $re!eating is on. but t!e circulation $'M$ and5)AT)6 are not %orking

& 7!en t!e 5)AT)6 is 0I1 type "rame T!e po%er o" circulation $'M$must reac! 9:;7

4 #onditions meet t!e abo8e 0&1 and t!e 5)AT)6 is still not%orking $lease c!eck t!e %ater le8el.and keep t!e %ater le8el abo8et!e %ater inductor

7 #irculation-cleaning <s the current time is as same as the preseting time0 the preset is >on@ too and the tu+ is filled with water0

the circulation cleaning will start0 the circulation pump wor$s at the same** (he #C shows the countdown time* <ll the surfing pumps and +lower will wor$ for 15 seconds at e4ery 15 minutes* (he O2onier wor$s at e4ery &6minutes .

(he circulation cleaning will +e turned off automatically once the countdown time is finished or y pressing

h “ ” $ ff di l *



AM

$UM$%

Fig.11 Radio frequency is &56*' MHG Sa4e the present frequency to channel 1 ASa4e channelB

or ?,change the frequency form channel 1 to the present ASearching channelB

“ ” is the O)/OFF $ey for radio and C and it is only a4aila+le in the status of power on* (he

first pressing “ ” is turning on the radio the second pressing “ ” will turn off the radio and turn on

the C at the same time and the third pressing> ” will turn off the radio and C simultaneous& #C will show present frequency and 4olume of the radio after turning on the radio' =n the wor$ing of radio (he 4olumle of the present radio frequency can +e changed +y pressing “

MI N ”and “ HOUR ”

Pressing the $ey ) SET * will ta$e out the memori2ed radio frequency Pressing the $ey )

SET ” continually will ta$e out the memori2ed radio frequency from channels will +e sa4ed at presentchannel +y pressing this $ey continually =f none of the channel #C will display >---@

+ Press the $ey ) MEM * could memori2e the present radio frequency Pressing the $ey )



1 Pressing the “ ” b!tto will start the constant temperature heating*

2 ith the setting a+o4e0 the circulation pump will wor$ automatically*

3 =f the temperature is set at 1 5℃- when the water temperature reaches or e,ceeds 1 #℃- the heater

will +e turned off automatically and the circulation pump will stop after 6 seconds* hen the water temperature

reaches or is lower than 1 .℃- the heater will start up again*# =n the case of an error the #C shows @?&@* =f this happens0 the thermostatic heating sytem will

)O( +e a4aila+le0 the heater doesn t wor$*

15 Fa!ren!eit = #elsius Temperature s!i"t

=n the status of “Power off ” pressing the $ey “F/ C

” can change the mode of Fahrenheit ; Celsius degree

16 hen the water le4el in the spa is under the the inductor 0 all surfing pumps0 +lower and heating system

can not start up* Howe4er the corresponding signals will flash on the #C *

17 $re8ent "ree>ing "unction?

(he heater ; circulation pump will wor$ automatically once the water temperature is +elow 6 0 when the water ℃

temperature is reach at &5 0 heating will stop* (his function is only a4aila+le while the spa is on normal power ℃

supply*

I! )lectric parameters

1 $er"ormance inde@ R d 4 l 220 50/ M i $i 60 220 V/0 "V1



g* Cleaning and disinfection

h*

%se and installation of a co4er*i* isposal of water

9* Precautions to a4oid damage due to water free2ing

$* Precautions to a4oid damage when the appliance is left empty for e,tended period*

& & Sub-clause 9

(he installation instruction shall state the su+stance of the followingE

- ?arthed appliances must +e permanently connected to fi,ed wiringD- (he appliance should +e supplied through a residual current de4ice ARC B ha4ing a rated residual

operating current not e,ceeding 15 m<*

- (he floor has to +e capa+le of supporting the e,pected load*

- <n adequate drainage system has to +e pro4ided to deal with o4erflow water*

- etails of how to follow the wiring rules0 for e,ample0 specifying that parts are installed in the correct 2one

and that equipotential +onding is carried out*

7A6

NIN

& <)J?R R=S. OF ?#?C(R=C SHOC. Connect only to a circuit protected +y a JroundFault Circuit lnterrupter*

' Jrounding is required* (he unit should +e installed +y a qualified ser4ice representati4e and

ground*

1 FOR KO%R S<F?(K-(his product should +e installed +y a professional ser4ice

technician0qualified in hydrotherapy +ath installation*

3 l hi i d 4 h i i h hi hil i *



ol!tio s o$ Fa!lt

P"e#o$e#o# Re%&o# Ho' (o Sol)e ("e *+o,le$

*o power s!pply 1. he electric leakage switch was breake" o$$

2. he F!se be break o$$

1. 7heck a " elimi ate the mal$! ctio ,restart the spa

2. 'lease cha ge $!se

*o "isplay o co trol pa el

1. he pl!g which co ecte" with the pa el loose or "isco ecte"

2. he 'a el happe e" with mal$! ctio

1. to co ect the pl!g o$ the co trol pa el a " the mai bo8

2. 7ha ge a ew co trol pa el

9:; light ot work 1. 'ower o$ the light be break o$$ 2. F!se be break o$$ 3. light be b!r

1. o check i$ cable o$ the light is wellco ecte" with mai bo8 or ot

2. 7ha ge a $!se

3. 7ha ge a ew lampwicko e ot work 1. o ater b!r2. F!se be break o$$ 3. 7able o$ the o o ater be c!t o$$

1. 7ha ge a ew o o ater 2. cha ge a $!se3. check i$ the cable o$ the mai power

is co ecte" with the mai bo8 orot.

;isplaie" “:1””FF” i

l l

1. temperat!re "etector be c!t o$$ or

h l

1. 7o ect the temperat!re "etector

h







1

Documents

SPA 413 Instructions