Minutes of meeting held between M/S CHUN CHAN TECH CO., LTD AND M/S Kalisma Steels pvt ltd on 22.10.2015.

Mr Leo Mr Shiva Kumar

Ms Jayce Liuvisited Mr Joshi

Mr Raza

Mr.Prabhat Dubey

Mr Tiwari

Service Engineer Mr. LEO YEH with tranlstor MS. JAYCE LIUVISITED THE Kalisma site on 19.10.2015 and started working. Worked till 22.10.2015 .

Following works done :

1) Machine installed in location and connected 230 V electrical power with

earthing.

2) air line 6 kg pressure connected .

3) Commissioned the machine.

4) Training started and from diameter and thickness checking. Then how to set

machine for production on 1st day. End of the day found that 3rd camera not working well.

5) 2nd day suspected the quality of power and informed to maintenance dept by Mr. LEO YEH regarding power. Voltage & Leakage checked and arranged transformer.

6) 2nd day Training started with all other parameters except surface defects & concentricity, roundedness. Trial taken for M6 X 30 bolts for with parameters :

a) Mixed parts b) Width c) Slant Threads d) Body length e)Major Dia f) Pitch g)Minor dia .h)Diameter

7. At the end of 2nd day found that there is a problem in surface defect detecting. Image setting problem it is giving problem in Collar thickness and comparing grades such as 9.8 and 8.8.

8. 3rd day Trail with 3 cameras Production rate checked up to 200 pieces/minute in m6x30 F.b.

9.Trained on surface defects & concentricity. Checked the running speed of the machine with one parameter at 350 pcs / minute. Found 372 pcs/minute.

10. Machine setting changed to m10 plate& as a Trail M8 bolts trial taken on m10 plate but it is not feasible to run , Also further M10 bolt trail taken this is also giving not good result as such it is having More Clearance in Plate(Size of Plate hole is 10.8.

11. Kalisma Team to run M8 bolts there is a Need of M8 Plate.

12. For the third camera situation, after checking the power, power supply should:

a. Separate power supply

b. Separate ground/earth connecting

* In Taiwan, we use a 5 meter long copper stick into the ground as ground/earth connecting

c. Machine voltage should not over 240V, otherwise will damage the machine

13. CCTech has remote connect system, if operator has any question in the future, CCTech can directly connect the sorting machine by internet.