Some question for RF TeamDo you have the answers to the below questions?) What is the purpose of drive test?2) Where we check the quality in tems kit?3) What is fdbm and sdbm? differentiate it?4) What is the ranges of Fdbm & Sdbm?5) What is handover in telecom?6) What is handover failure?7) How u will determine the particular cell is overshooting while performing drive test?8) Whats are the reason for quality degradation?9) Whats is BCCH frequency and what is TCH frequency?10) In idle mode fdbm, sdbm and RxQual value visible or not?11) Where you observed data in tems?12) When you establish internet connection which even comes first?13) What is Ec/No in 3g?14) What is AS, NS and DN?15) Pilot pollution?16) How you monitor data in 3g?17) How much active set can be there in neighbor window?18) What is IRAT?WCDMA Introduction and Overview WCDMA concept and Architecture Spreading and Scrambling Codes and Channels Code tree Rake Receiver Soft, Softer and Hard hand over Power control - fast and slow WCDMA Drive test Overview using TEMS Investigation TEMS Parameter for WCDMA Optimization Tips for WCDMA WCDMA Tools for Drive Test 3G Voice Call Testing 3G Packet call & Video call testing 3G Drive test KPI overview 3G Optimization overview