The Challenge An existing Ariel JGH/2 compressor Operator in Pennsylvania had an op-erational problem in a gas turbine booster application. The compressor system was designed to feed compressed natural gas into a turbine at a constant discharge pres-sure. The actual gas flow in the application is based on the requirements of the tur-bine which is dictated by the power de-mand on the system. The existing suction scrubber was un-dersized and inadequately removed water from the moist gas stream. As a result, the compression rate and required pressure were difficult to main-tain. The Equipment Turbine Model: Ariel JGH/2 Flow Rate: 300 ACFM Gas Temperature: 100 Degrees F Operating Pressure: 125 PSI Gas Stream: Saturated Methane

Natural Gas Booster Suction Scrubber for Water Removal

SOLBERG Oil Mist Solutions Innovative Solutions

®

The Solution Solberg built a 150 PSI rated ASME code pres-sure vessel (PCSS Series) to replace the existing suction scrubber. The vessel was equipped with a Teflon coated polyester filter element (99.97% efficient for water and fine particulate re-moval.) The element is designed to have a ser-vice interval of one year, which makes it mainte-nance free. The solution was devised in conjunction the Op-erator. The solution fit into their existing piping arrangement and was installed with minimal sys-tem modifications. Installation The Operator handled the installation at their plant in Pennsylvania. Solberg technical support and engineering were in constant communication with the Operator during the process to ensure all questions were answered and challenges resolved.

www.oilmistsolutions.com sales/service: 630.616.4411

Results Periodic reviews are conducted to en-sure that all needs are met. At this point, the Operator is pleased with the water removal and more efficient com-pressor performance.

Natural Gas Booster Suction Scrubber for Water Removal

Solberg Oil Mist Solutions 1151 Ardmore Ave. ● Itasca, IL 60143 USA Solberg – Discover the Possibilities

CS NGB-A8135 www.oilmistsolutions.com sales/service: 630.616.4411

2

1

3

4

System Components 1. Inlet/Outlet: Raised face 150 pound

ANSI flanges

2. Internal Separator Element: De-

signed to be 99.97% efficient for wa-

ter and fine particulate removal from

the saturated gas stream. Built with

Teflon coated polyester media and

stainless steel components

3. Leg Supports: Specifically sized to

allow for easy installation into the Op-

erator’s existing piping

4. Drain Port: This 1/2” port is in-

cluded to conveniently drain any

collected water

Inlet

Outlet