BETTER. SAFER. FASTER.™

A D V A N C I N G H E AT T R E AT M E N T™

superheat.com • 1.888.508.3226 • sales@superheat.comcopyright © 2018 Superheat. All rights reserved

6”8” HB

20” Insulation

1” 6# density insulation double layer over healers

1-H1530073 /1

Wrapping Specifications Sheet

ASME - Butt Weld - 4” PWHT - Horizontal Drawing#: MNA-P-4-PW-BW-S80-AS

Superheat Office: Houston, TX

Drawn By: AZDate: 31 May 2017WO#: 4378 Demo

Weld# W1 Heater Spacing0” Gap

Line # 4-LP-275-1 Drawn By: AZ PDF#: 110017THE INFORMATION CONTAINED HEREON WHICH IS THE PROPERTY OF SUPERHEAT FGH, MUST BE MAINTAINED IN CONFIDENCE AND NO PORTION OF THIS DRAWING

MAY BE PRODUCED OR USED, WITHOUT THE EXPRESS WRITTEN PERMISSION OF THE COMPANY.

Note: - Elevation view unless otherwise stated - Double Insulation over heating elements - Insulation standard 1” thickness - 6 # density. - - Denotes Control T/C near side - - Denotes Monitor T/C - - Denotes T/C far side

Customer Acceptance of Heat Treating MethodThe client has reviewed the above drawing and assumes responsibility

for misalignment, distortion, collapse, or deformation. The signature below

represents the client’s acceptance of this drawing.

(Signature) (Date)(Print Name)

Pak 30073

b Set Pt OP % A B

b

r

o

0 GO C C

C D E F

FD-SH273 REV 1 UNCONTROLLED IF PRINTED PAGE 2 OF 4

SET UP WELD1

SUPERHEAT SMARTWRAP™ ADVANTAGES

Wrapping Spec Sheet

SUPERHEAT MANAGES

SAVE TIME: Control your maintenance schedule by reducing heat treatment contractor wait time.

REDUCE COSTS: Improved labor utilization equals less variable costs.

IMPROVE QUALITY: Real-time monitoring and procedural support 24/7.

MINIMIZE RISKS: Remote monitoring and safety lock-out decreases man hours in hazardous areas.

RUN HEAT CYCLE STRIP WELD DELIVERQA PACKAGE

2 3 4

CLIENT MANAGES