Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
Slider Indoor Banner Stand —QUICK INSTRUCTIONS
STEP3Slide the graphic to side poles
STEP1Grab 2 of the poles with the capped tops and screw on the feet to the bottom of the poles using a screw driver. Tighten very well
STEP6Grab the other long pole (top pole) and slide it through the top pole pocket
STEP4Slide bottom pole (connected with 3 pole parts) to the bottom pole pocket
STEP5Unscrew and lift up the foot poles a little bit to open up the holes on the bottom of the pole near the feet.
STEP2Make sure to extend the side pole to open the hole to screw the pole in step 5.
• 2 - 3 Piece expandable Poles with Top and bottom screw holes
• 2 - 3 Piece expandable Poles with bottom screw hole and capped top
• 2 Feet
• 6 Hand tightening screws
• 1 Graphic (for graphic order)
STEP8Extend the top and bottom pole to desired length.
STEP9Recommended one person stand on each side raising the side of the graphics to desired length.Start by extending the side poles to desired length by adjusting screw tighteners on the side poles.
STEP7Screw tight with each side pole.