Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
HID Slider
Finished Product
Assembly Instructions
- May vary between signs.
J
K
I
H
G
F
E
D
C
A
Color/FinishPart ID. Qty. Material
Parts List
-
-
Frame 2
Frame with Sintra 1
-
Silver 311-304Slider - / ” Acrylic
-
G
F
E
D
C
B
A
End Cap 2
K
J
Anodized AluminumExtruded Aluminum
Anodized Aluminum, BlackExtruded Aluminum, Sintra
SilverInjection Molded
Formica
Paper Insert
Lens
BlackMicroDot Formica
May Vary By SignPaper
Clear Non-GlareAcrylic
Anodized AluminumSlider J Cap Extruded Aluminum
Other Parts (May Be Included with Sign)
-Divider
-
SilverExtruded Rubber
Anodized AluminumSlider Divider Extruded Aluminum
May Vary By Sign
Slider Lens -
H
I
321
Slider Vinyl -
Clear Non-Glare
Vinyl with 3M 3645 Luster Over Laminate
Acrylic
L
L
B
J
Step 1
Insert the frame (A) into the aluminum end of the frame with sintra (B) as shown. Make sure that the tab on the frame (i) is in line with the third slot from the end (ii) in order to create a flat face. Repeat for both frame sections.
Step 2
Step 3
Apply the slider vinyl (H) to the slider lens (G). Slide the slider J cap (I) into the sign. Then, slide the slider lens (G) into the correct slot (iii) in the sign.
Step 4
Slide the slider (F) into the correct slot (iii) in the sign. Slide the slider J cap (I) into the sign as shown, making sure that the slider falls into the groove (iv) in the slider cap. *NOTE: If there is more than one slider, repeat steps 3 and 4, but with the slider divider (L) in between the two sliders.
Step 6
Step 5
Slide the formica (C) into the correct slot (v) in the sign. Then, slide the paper insert (D) and the lens (E) into the correct slot (vi) in the sign. *Note: If there is a divider (K), slide it into the sign inbetween sections of formica, paper inserts, and lenses. Repeat this step for all sections of formica, paper inserts, lenses, and all dividers.
Align the end cap (J) with the appropriate slots on the bottom of the sign, as shown. Push theend cap into place. A rubber mallet my be necessary to press the end cap in all the way.
Align the end cap (J) with the appropriate slots on the top of the sign, as shown.Push the end cap into place, using a rubber mallet if necessary.
A
B
I
I
F
iv
I
F
K
L
E
D
C
A
B
i
ii
J
H
G
G
I
iii
v vi