7/25/2019 Single Phase Revers
1/2
Single-Phase Capacitor Start-Capacitor Run MotorsConnection
Diagram
4APCC
L1 N E L1 N ETo change direction of rotation simply re-position
the 2 metal links in the terminal box.
IMPORTANT ! Always check the motor nameplate for correct voltage
and the inside ofthe terminal box lid for the correct wiring
diagram.
Ask if in doubt !Incorrect wiring will damage the motor and
invalidate the Warranty!
ROTOR (UK) LIMITED, 16 Everitt Close, Denington Industrial
Estate, Wellingborough NN8 2QFTel 01933 230900 Fax 01933 272152
[email protected] www.rotor.co.uk
MAIN WINDING
STARTWINDING
01 02 Z2
U1 Z1 U2
MAIN WINDING
START
WINDING
01 02 Z2
U1 Z1 U2
In order to use a change-over switch it is necessary to
reconnect the internal terminationon the terminal block in the
following way:
ROTOR (UK) LIMITED cannot be held responsible for any
damages caused by incorrect wiring.
The re-connection must be carried outby a qualified electrician
!
MAINWINDING
STARTWINDING
01 02 Z2
U1 Z1 U2
L N L(N) N(L)
1. Disconnect cable fromand connect it to
Start WindingZ2 02
2. Disconnect cable fromand connect it to
Main WindingU1 Z2
Supply to at all times.Supply to at all times.Swap and to andto
change direction of rotation.
L U1N Z1
L N U2 Z2
7/25/2019 Single Phase Revers
2/2
Single-Phase Capacitor Start-Capacitor Run MotorsConnection
Diagram
7AACC
L1 N E L1 N ETo change direction of rotation simply re-position
the 2 metal links in the terminal box.
IMPORTANT ! Always check the motor nameplate for correct voltage
and the inside ofthe terminal box lid for the correct wiring
diagram.
Ask if in doubt !Incorrect wiring will damage the motor and
invalidate the Warranty!
ROTOR (UK) LIMITED, 16 Everitt Close, Denington Industrial
Estate, Wellingborough NN8 2QFTel 01933 230900 Fax 01933 272152
[email protected] www.rotor.co.uk
MAIN WINDING
START
WINDING
MAIN WINDING
START
WINDING
In order to use a change-over switch it is necessary to
reconnect the internal terminationon the terminal block in the
following way:
ROTOR (UK) LIMITED cannot be held responsible for any
damages caused by incorrect wiring.
The re-connection must be carried outby a qualified electrician
!
MAINWINDING
STARTWINDING
U1 Z2 U2
L(N) N(L) L N
1. Disconnect cable fromand connect it to ( )
Start WindingZ1 C the middle C
2 Disconnect cable fromand connect it to
Main WindingU2 Z1
Supply to at all times.Supply to at all times.
Swap and to andto change direction of rotation.
L Z2N U2
L N Z1 U1
Z1 C C Z1 C CZ1 C C
U1 Z2 U2 U1 Z2 U2
Z1 C CZ1 C C
