SHEET LINE

SL Series

Roll Face Width (inches) Polishing Roll Dia. (inches)

8 14 20 28

Draw Roll Dia. (inches)

Drive HP (each)

8 SL88 SL814 SL820 SL828 4 1 12 SL128 SL1214 SL1220 SL1228 6 1 ½ 16 SL168 SL1614 SL1620 SL1628 6 2

PROGRAMMABLE CONTROLS: • 4.1” LCD touch screen HMI • Proprietary software driven display

- Guides operator through set-up and prevents input errors

• Start pushbutton • Emergency stop pushbutton

- All roll nips open on emergency stop • Remote draw roll start/stop pushbutton • Independent open/close pushbuttons for both top and

bottom polishing rolls and draw rolls • Adjustable acceleration and deceleration • Max./min. speed adjustments • Gap setting and roll protection are jack screw actuated

- .025” vertical movement per revolution of handle

POLISHING ROLL STAND: • Three-roll s-wrap, down-stacked • Double shell spiral baffled rolls • Non-binding lineal motion; open/close • Max. opening – 4” • Fluid Passage – ¾” NPT

- ¾” NPT rotary unions installed inlet and outlet • Roll surface – eight micro-finish

- Single hard chrome plated to .010” thickness - Roll concentricity ± .001”

• Max. nip closing force – 150 lbs./lineal inch • Nip Actuation – pneumatic as standard (other options

available) - Jack screw adjustment up to 1” - .025” movement per revolution of jack screw - Closed gap tolerance ± .001” - Independent stops for left and right roll adjustment

DRAW ROLL STAND: • Two-roll, vertically aligned • 70 A durometer natural rubber covered rolls

- Surface ground to .5” thickness • Nip pneumatically actuated

- Max. nip opening – 4” - Nip lineal force adjustable to a max. of 100 of 100

lbs./lineal inch

FRAME: • Heavy wall tubing, steel plate and structural sections • Two rigid and two swivel casters and hold-downs • Screw type floor jacks • Fully guarded drive train and electrical components

ELECTRICAL: • Standard Electrical is 230 Volt/3 Phase/60 Hertz

- Electrical other than the above is available as an option

OPTIONS: • Hardened rolls • Lower micro-finishes on roll surface • Three zone direct injected or closed circuit temperature

control unit; 250ºF max. 9 KW Heater • Automatic Vent; LED set point and display with system

status indicators • High temperature draw roll surface compounds • Floor tracks with or without drive for 36” movement of

sheet line • Hydraulic nip actuation • Dual hard chrome plate for corrosive materials