Upload
dinhminh
View
213
Download
0
Embed Size (px)
Citation preview
CODEAbbott Diabetes Care Inc. 1360 South Loop Road, Alameda, CA 94502 ART
3650
5 Rev
. 1 01
/16
FreeStyle LibreSensor Applicator
Aplicador del sensor
XXXXXXXXXXX
YYYY-MM-DD
XXX
CODE
Abbott Diabetes Care Inc. 1360 South Loop Road, Alameda, CA 94502 A
RT36504 R
ev. 1
08/1
5
Sensor Pack | Envase del sensorCustomer Service | Atención al cliente:
1-855-632-8658
XXXXXXXXXXX
XXX
YYYY-MM-DD
FreeStyle Libre
STEP 3
STEP 6
STEP 9
Get
Rea
dy
Ap
ply
Sen
sor
Pre
par
e Se
nso
r A
pp
lica
tor
Clean site with alcohol wipe. Allow site to dry before proceeding.
Peel lid completely off Sensor Pack. Unscrew cap from Sensor Applicator.
CAUTION: Sensor codes must match on Sensor Pack and Sensor Applicator or glucose readings will be incorrect.
Select site on back of upper arm.Do not use other sites as these are not approved and may result in inaccurate glucose readings.Note: Avoid scars, moles, stretch marks, lumps, and insulin injection sites. To prevent skin irritation, rotate sites between applications.
Refer to your User’s Manual for full system instructions and information.
Touchscreen
Home ButtonUSB Port
Sensor Pack
Reader
Place Sensor Applicator over site and push down firmly to apply Sensor.
CAUTION: Do not push down on Sensor Applicator until placed over prepared site to prevent unintended results or injury.
Make sure Sensor is secure. Discard used Sensor Applicator and Sensor Pack according to local regulations.
Gently pull Sensor Applicator away from your body.
Quick Start Guide
STEP 1
STEP 4
STEP 7
STEP 2
STEP 5
STEP 8
Line up dark mark on Sensor Applicator with dark mark on Sensor Pack. On a hard surface, press down firmly on Sensor Applicator until it comes to a stop.
Sensor Applicator is ready to apply Sensor.
CAUTION: Sensor Applicator now contains a needle. Do not touch inside Sensor Applicator or put it back into Sensor Pack.
Lift Sensor Applicator out of Sensor Pack.
Lid Cap
Sensor
SensorApplicator
Codes on labels must match
● 1 Assemble and Apply Sensor to the back of your upper arm
● 2 Start new Sensor with Reader
Wait 12 hours for start-up
You can check your glucose whenever you want for up to 10 days
Setup Overview
● 1 Assemble and Apply Sensor to the back of your upper arm
FLASH GLUCOSE MONITORING SYSTEM4.5”
4.5”
4.5”
No Active Sensor
10:23pm
Start NewSensor
ReviewHistory
350
250
150
50
236 mgdL
6am 10am 2pm
Glucose Going High
Check Glucose
Scan Sensor to checkglucose.
10:23pm
CheckGlucose
ReviewHistory
Ends in 10 days
Daily Patterns
Time In Target
Low Glucose Events
Sensor Usage
Logbook
Daily Graph
Average Glucose
Review History
1 / 2
hours
OKNew SensorStarting Up
12 Sensor can be used in:
350
250
150
50
350
250
150
50
92 mgdL
mg/dL
Food Note
TargetGlucose
Range
Rapid-ActingInsulin Note
CurrentGlucose
Time
MessageTouch for more information
Check Blood GlucoseWhen you see this
symbol, do a blood glucose test before making treatment
decisions
Add NotesTouch to add notes to glucose reading
Current GlucoseGlucose from your latest scan
Glucose Trend ArrowDirection your glucose is goingGlucose Graph
Graph of your current and stored glucose readingsArrow What it means
Glucose rising quickly
Glucose rising
Glucose changing slowly
Glucose falling
Glucose falling quickly
Glucose Going Low
2pm 6pm 10pm
2pm 6pm 10pm
Press Home Button to turn on Reader.Note: If using Reader for the first time, follow the prompts to set date, time, and target glucose range.
Touch Start New Sensor. Hold Reader within 1.5 inches (4 cm) of Sensor to scan it. Sensor can be used to check your glucose after 12 hours.
Press Home Button to turn on Reader. Press Home Button again to go to Home Screen.
Touch Review History. Select option to view.
Hold Reader within 1.5 inches (4 cm) of Sensor to scan it.
Press Home Button to turn on Reader. Reader shows your glucose readings.
Understanding your glucose readings
If you have followed the instructions described in the User’s Manual and are still having difficulty setting up your System or if you are experiencing symptoms that are not consistent with your glucose monitoring, contact your health care professional.
STEP 3
STEP 3
STEP 3
STEP 1
STEP 1
STEP 1
STEP 2
STEP 2
STEP 2
FreeStyle, Libre and related brand marks are trademarks of Abbott Diabetes Care Inc. in various jurisdictions. ©2017 Abbott ART28734-018 Rev. B 09/17
Manufacturer
Consult instructions for use
WARNING: When you see the symbol, you must check your blood glucose with a blood glucose meter before making any treatment decisions. Sensor readings may not accurately reflect blood glucose levels.
● 2 Start new Sensor with Reader
● 3 Check your glucose
● 4 Review your history
4.5”
4.5”
4.5”