2x

2x

2x

2x

2x

Input 1 Input 2

Digital Audio Out

Optical HDMI Ethernet

12V DC5A max

USB5V DC 500mA

Coaxial

13V/18VDC350A maxCombined

TV aerial

Setting up your iQ3Here’s how to set up your iQ3 to access the world of Foxtel entertainment.

1 First up, let’s check you’ve got all the goods

2 Connect your iQ3 to your TV

3 Pair your Bluetooth remote

5 Connect your iQ3 to the internet

6 Tune your free-to-air channels

– If you’re upgrading your box, use your existing Foxtel, HDMI and Ethernet cables where possible.

– Once you’re connected, turn your TV back on and select the HDMI source you’ve connected to.

– You will see a black screen for a couple of minutes and then just follow the prompts.

To get the most out of your iQ3 features, connect your Ethernet cable from your internet access point to the back of the iQ3, or connect to WiFi by following these steps:

To receive your free-to-air channels* off your TV aerial, check you’ve connected your iQ3 to your aerial wall plate, then:

Need a helping hand? For iQ3 tips and tricks, check out your welcome book enclosed or view the Help videos in the ‘Using iQ3’ section of your Home menu. For troubleshooting or support, go to the ‘Help’ section in your Settings menu or visit foxtel.com.au/support

Select Home on your iQ3 remote, then arrow right and select Settings.

Select Home, arrow right and select Settings.

Select WiFi.

Select Full Scan.

Select Internet Connection.

Select Terrestrial Channels from Settings.

Select your network.

Select Begin Scan.

Enter your WiFi password, select Done and you will be advised once connected.

Once scan is complete select View TV Guide.

Remote and Batteries

iQ3 Box TV Aerial Cable and Adapter

Foxtel Cables (new customers only)

Ethernet CableHDMI Cable Power Lead with Power Pack

FOX

09

30 0

4/17

iQ

3 S

AT

*Free-to-air channels will vary based on location. Not all channels are available in all areas.

4 Call 1300 732 681 to activate your iQ3

Insert the batteries provided into your remote. The blue light on your remote will start flashing.

Press and hold the Home button on the iQ3 remote until the light at the top of your remote stops flashing and remains blue, then you’re all set!

Once the standby button on your iQ3 has turned blue, bring your remote to the front of your box. Brush your hand slowly across the front of your iQ3 until the front panel lights up.

Don’t be a maverick – make sure your TV (and existing Foxtel box if you have one) is turned off at the wall.

To TV aerialwall plate (optional)

To Foxtelwall plate

To TV To internet access point(optional, see step 5)

To power point

FOX0930_iQ3_SAT_C1.indd 1 19/04/2017 4:24 PM