Session Plan OF CATIA Basic

Basics of Engineering Drawing (Special class)

Session 1: Introduction to CATIA Need of Solid Modeling Basic Terms Drafting and Designing Parametric Technology Bidirectional Associativity Introduction to Sketcher.

Session 2: Sketcher Introduction to Constraining Applying Constraints Creating sketches using constraints.

Assignment 1 & 2

Session 3: Creating Sketch Based Features- Pad Features Multi pad Features Pocket And Multi pocket Drafted Filleted Pad Drafted Filleted Pocket.

Assignment 3

Session 4: Shaft Groove Hole.

Session 5: Creating Datum Planes Datum Axis Datum Points

Session 6:

Dress up features- Edge Fillet Chordal Fillet Variable Radius Fillet Face Face Fillet Tri Tangent Fillet Chamfer

Assignment 4 & 5

Session 7: Draft Angle Draft Reflect Line Variable Angle Draft.

Session 8: Shell Thickness Remove Face Replace Face

Assignment 6

Session 9: Transformation Features-Translation Rotation Symmitry Axis to Axis Mirror Rectangular Pattern Circular Pattern User Pattern Scaling

Session 10: Rib Slot And Solid Combine Stiffner Thread Tap

Assignment 7

Session 11: Multi section Solid

Removed Multi section Solid.

Session 12: Boolean Operation-Add Remove Intersect

Session 13: Assembly Modeling Types of Assembly Design Approaches Creating Bottom up Assemblies Inserting Components in a Product File Moving Individual Components Applying Constraints

Assignment 8

Session 14: Creating Top down Assemblies Creating Base Part in the Top down Assembly Creating Subsequent Components in the Top down Assembly Creating Subassemblies in the Top down Assembly Editing Assemblies Deleting Components & Remove

Assignment 9

Session 15: Replacing Components Editing Components inside an Assembly Editing Subassemblies inside an Assembly Editing Assembly Constraints Simplifying the Assembly Interference Detection Sectioning an Assembly Exploding an Assembly.

Assignment 10Doubt Clearing Session