T R E C E T E C H N O L O G Y ́ ´

INSECT PHEROMONE & KAIROMONE SYSTEMS

INCORPORATED

®

Your Edge – And Ours – Is Knowledge.

SECURE TRAP PLACEMENT & FLEXIBLE RELOCATION!

For use with the Standard DOME or QUICK-CHANGE DOME TRAP™ ™ ™

The NEW STORGARD DOME™ TRAP HOLDER is a very simple, robust device that secures the standard DOME™or QUICK-CHANGE™ DOME™ TRAP from being moved when subjected to cleaning procedures or any strong air movement inside your facility or structure.

Standard DOME™ TRAP

QUICK-CHANGE™ DOME™ TRAP

Key Features:

· Convenient· Semi-permanent trap placement· Traps stay in place· Long lasting· Simple snap closure

Benefits:

· Easy to install, maintain and move· Flexible relocation· Consistent location and attraction· Low cost· Fast trap count and maintenance

Contact your local supplier and order now.Visit our website: www.trece.com or call 1- 866 -785-1313.

1. 2a.

4. 5.

TRE-0715, 3/15

Visit our website or call toll-free:1-866- 785-1313

www.trece.comINSECT PHEROMONE & KAIROMONE SYSTEMS

INCORPORATED

®

Your Edge – And Ours – Is Knowledge.

© 2015, Trécé Inc., Adair, OK USA • TRECE, PHEROCON and CIDETRAK are registered trademarks of Trece, Inc., Adair, OK USA

A. B. C.

For use with the Standard DOME™ or QUICK-CHANGE™ DOME™ TRAP

6. 9.8.

The DOME™ Trap HOLDER features four small holes to anchor the HOLDERto the floor using screws, glue, double-sided tape or adhesive-back velcro. The design of the HOLDER allows the air to flow around and inside the trap for proper release of pheromones and kairomones into the surrounding environment. The top Bow holds the trap in place with a snap closure that can be easily opened and closed for trap counting and maintenance.

1. Remove components from carton. Each carton includes: A. Base (10) B. Adhesive-back Velcro (20) C. Bow (10)

2. Secure the Base by one of the following: screws no greater than .20” (1/5”) in diameter, a suitable adhesive system (i.e. Adhesive-back Velcro), or silicone. Be careful not to alter the shape of the support. Place the DOME Trap within Base

in desired location3. Secure the Bow onto the Base with a slight pressure on the

lever located at the ends and push until it clicks. Repeat the operation on the other end of the Bow. The DOME Trap is now secured in its position

4. To access the trap, press the tab on one end of the Bow to open the snap closure

5. Lift one end of the retainer Bow to allow access to the DOME Trap

6. Remove the DOME Trap from the HOLDER 7. For the QUICK-CHANGE DOME Trap, remove the lure tray from the DOME Base to service. For the Standard DOME Trap, remove the top of the DOME Trap for servicing

8. After servicing, place the DOME Trap into the HOLDER

9. Secure the Bow onto the Base of the DOME Trap HOLDER

7a.

7b.

QUICK-CHANGE DOME Trap

Standard DOME Trap

2b. 3.