SECTION VIEW QUIZ

Write your name on your paper!

1.) What is the purpose of Sectional Views?

2.) Draw a Cutting plane Line

3.) Where does Sectional Lining go?

4.) Where does the sectional view go in relationship to the

Cutting Plane Line?

5.) What is it called when we only show the inside of

half the view?

6.) When looking at a section of an assembly, how can I tell

that it is made of more than one material?

7. ) In mechanical drawing, what is the furthest apart the lines

should be in sectional lining?

8.)Which type of line should be the heaviest, darkest, and stand

out the most on your paper?

9.) What angle does the path of the Cutting Plane turn for an

Offset Section?

10.) What must you do to place the section view any where other then in the adjacent view behind the arrows

of the CPL?

?

BONUS.) Where does the left side view go in relationship to

the the Front side view?

?

Sectional Views Quiz

Exchange quiz’s w/ someone sitting next to youCheck to see their name and period is on topPlace your initials on the bottomClearly mark any unanswered question wrong

before we get started

1.) What is the purpose of Sectional Views?

Show the inside to avoid confusion

2.) Draw a Cutting plane Line

3.) Where does Sectional Lining go?

on surfaces that touch the Cutting Plane.

4.) Where does the sectional view go in relationship to the

Cutting Plane Line?

In the adjacent view behind the arrows! (or a clearly labeled removed view)

5.) What is it called when we only show the inside of half the

view?

Half Section

6.) When looking at a section of an assembly, how can I tell that

it is made of more than one material?

The Sectional Lining is at different angles for each material (or different Hatch patterns for each material)

7. ) In mechanical drawing, what is the furthest apart the lines should be in sectional lining (aka cross hatch)?

3/16”

8.)Which type of line should be the heaviest, darkest, and stand

out the most on your paper?

Cutting Plane Line

9.) What angle does the path of the Cutting Plane turn for an

Offset Section?

90° turn

10.)What must you do to place the section view any where other then in the adjacent

view behind the arrows of the CPL?

label the drawing & reference it behind/or alongside the arrows of the CPL and the page # if on a different page

BONUS.) Where does the left side view go in relationship to

the the Front side view?

DIRECTLY TO THE LEFT