Section 09 Gravimetric Analysis(powerpoint)

Section 09

Gravimetric Analysis and Precipitation Equilibria

How to Perform a Successful Gravimetric Analysis

• What steps are needed?1. Sampled dried, triplicate portions weighed2. Preparation of the solution3. Precipitation4. Digestion5. Filtration6. Washing7. Drying or igniting8. Weighing9. Calculation

Gravimetric Analysis • Gravimetric Analysis – one of the most accurate

and precise methods of macro-quantitative analysis.

• Analyte selectively converted to an insoluble form.• Measurement of mass of material • Correlate with chemical composition• Why?• Simple• Often required for high precision

Gravimetric Analysis• How?• Quantitative collection of material of

known composition– Precipitation of analyte with selective agent– Volitization and collection of analyte– w/o loss of material in handling/processing– Free from solvent, impurities

• Determination of mass– Direct or– By difference

Gravimetric Analysis• Precipitation Techniques

– Add precipitating reagent to sample solution– Reacts with analyte to form insoluble material– Precipitate has known composition or can be converted

to known composition• Precipitate handling involves

– Quantitative collection (no losses)– Isolation of pure product

• Measure mass of precipitate• Calculation of original analyte content

(concentration)

Gravimetric Analysis• Desirable properties of analytical

precipitates:– Readily filtered and purified– Low solubility, preventing losses during

filtration and washing– Stable final form (unreactive)– Known composition after drying or ignition

Gravimetric Analysis• Precipitating reagents:• Selective • Ag+ + Halides (X-) AgX(s)

• Ag+ + CNS- AgCNS(s)

• Specific• Dimethylglyoxime (DMG)• 2 DMG + Ni2+ Ni(DMG)2(s) + 2 H+

Gravimetric Analysis• Filterability of Precipitates:• Colloidal suspensions

– 10-7 to 10-4 cm diameter– Normally remain suspended– Very difficult to filter

• Crystalline suspensions– > tenths of mm diameter– Normally settle out spontaneously– Readily filterable

Gravimetric Analysis• Filterability of Precipitates:

– Precipitate formation affected by – RELATIVE SUPERSATURATION(R.S.)

• R.S. = (Q-S)/S– S = Equilibrium Solubilty of Precipitate– Q = Instantaneous Concentration

• Larger Q leads to colloidal precipitates.

Important Factors for Gravimetric Analysis

• Nucleation– Individual ions/atoms/molecules coalesce to

form “nuclei”• Particle Growth

– Condensation of ions/atoms/molecules with existing “nuclei” forming larger particles which settle out

• Colloidal Suspension– Colloidal particles remain suspended due to

adsorbed ions giving a net + or - charge


• Coagulation, agglomeration– Suspended colloidal particles coalesce to form larger

filterable particles (inert electrolyte allows closer approach)

• Peptization– Re-dissolution of coagulated colloids by washing

and removing inert electrolyte


• Co-precipitation– Normally soluble compounds carried down

with insoluble precipitate (surface adsorption, occlusion, mixed crystals, entrapment)

• Digestion– Precipitation heated for hour(s) in contact with

solution form which it was formed

Fig. 10.1. Ostwald ripening.

During digestion at elevated temperature:

Small particles tend to dissolve and reprecipitate on larger ones.

Individual particles agglomerate.

Adsorbed impurities tend to go into solution.

©Gary Christian, Analytical Chemistry, 6th Ed. (Wiley)

Fig. 10.2. Representation of silver chloride colloidal particleand adsorptive layers when Cl- is in excess.

Cl- adsorbs on the particles when in excess (primary layer).

A counter layer of cations forms. The neutral double layer causes the colloidal particles to coagulate.

Washing with water will dilute the counter layer and the primary layer charge causes the particles to revert to the colloidal state (peptization). So we wash with an electrolyte that can be volatilized on heating (HNO3).


Organic precipitating agents are chelating agents.

They form insoluble metal chelates.


Gravimetric Analysis

• Calculations of analyte content requires knowledge of :

• Chemistry• Stoichiometry• Composition of precipitate

Gravimetry and Solution Equiliria• Thermal Conversion to Measurable Form• Removal of volatile reagents & solvent• Extended heating at 110 to 115 OC• Chemical conversion to known stable form• CaC2O4(s) CaO(s) + CO(g) + CO2(g)

• Volatilization & trapping of component• NaHCO3(aq)+ H2SO4(aq) CO2(g)+ H2O +

NaHSO4(aq)

Gravimetric Calculations

• Gravimetric Factor (GF):• GF = (fwt analyte (g/mol)/fwt

precipitate(g/mol))x(a(moles analyte/b(moles precipitate))

• GF = g analyte/g precipitate• % analyte = (weight analyte (g)/ weight sample

(g)) x 100% • % (w/w) analyte (g) = ((wt ppt (g) x GF)/wt

sample) x 100%

Gravimetric Errors• Unknown Stoichiometry:• Consider Cl- determination with AgNO3

• Ag+ + Cl- AgCl• Ag+ + 2 Cl- AgCl2

• Gravimetric Factor: • GF = fwt analyte/fwt precipitate x moles

analyte/moles precipitate• Calculation for Cl- = wt. Ppt * GF

Gravimetric Errors

Fwt analyte grams

Fwt ppt grams

Molesanalyte

Moles ppt

Gravfactor

Weigh ppt grams

Weigh analyte grams

35.453 143.32 1 1 .2474 .606 0.1499

~0.150

35.453 178.77 2 1 0.3966 .606 0.2403

~0.240

Gravimetric ErrorsCo-precipitation: (w/AgCl)

Co-precipitant Error Rationale

NaF Positive All NaF is excess

NaCl Negative Fwt Na<Ag

AgI Positive All AgI is excess

PbCl2 (fwt 278.1) Negative Gravimetric Factors decreases

Alternative Gravimetry Technique• Homogeneous Precipitation• What?

– Precipitating agent generated slowly by chemical reaction in analyte solution

• Why?– Precipitant appears gradually throughout– Keeps relative supersaturation low– Larger, less-contaminated particles

• How?– (OH-) by urea decomposition– (NH2)2CO 2 OH- + CO2 + 2 NH4

+

– (S=) by thioacetamide decomposition– CH3CSNH2 H2S + CH3CONH2

– (DMG) from biacetyl + hydroxylamine– CH3C(=0)-C(=0)CH3 + 2 H2NOH DMG + 2 H2O

Precipitation Equilibria:The Solubility Product

• Solubility of Slightly Soluble Salts:• AgCl(s)(AgCl)(aq) Ag+ + Cl-

• Solubility Product KSP = ion product

• KSP = [Ag+][Cl-]

• Ag2CrO4(s) 2 Ag+ + CrO42-

• KSP = [Ag+]2[CrO42-]

The molar solubility depends on the stoichiometry of the salt.

A 1:1 salt is less soluble than a nonsymmetric salt with the same Ksp.


Precipitation Equilibria:The Common Ion Effect

• Common Ion Effect• Will decrease the solubility of a slightly

soluble salt.

Fig. 10.3. Predicted effect of excess barium ion on solubility of BaSO4.

The common ion effect is used to decrease the solubility.

Sulfate concentration is the amount in equilibrium and is equal to the BaSO4 solubility.

In absence of excess barium ion, solubility is 10-5 M.


Diverse Ion Effect on Solubility:• Presence of diverse ions will increase the

solubility of precipitates due to shielding of dissociated ion species.

• KSPo and Activity Coefficients

• AgCl(s)(AgCl)(aq) Ag+ + Cl-

• Thermodynamic solubility product KSPo

• KSPo = aAg+

. aCl- = [Ag+]ƒAg+. [Cl-]ƒCl-

• KSPo = KSP

ƒAg+. ƒCl-

• KSP = KSPo/(ƒAg+

. ƒCl)

Predicted effect of increased ionic strength on solubility ofBaSO4. Solubility at zero ionic strength is 1.0 x 10-5 M.

Ksp = Ksp0/fAg+fSO42-

Solubility increases with increasing ionic strength as activity coefficients decrease.


Gravimetric calculation using spreadsheet.

Cell B3 calculates %Fe from g. Fe2O3 (Cell D2) and g. sample (Cell B2).


Using Exel Solver to calculate solubility.

Enter the formula (=s2/Ksp) in Cell E4 (don’t enter =1; that goes in Solver).

The value of s (Cell C4) is changed iteratively until the formula equals 1.


Calculating Results from Gravimetric Data

• The calcium in a 200.0 mL sample of a natural water was determined by precipitating the cation as CaC2O4. The precipitate was filtered, washed, and ignited in a crucible with an empty mass of 26.6002 g. The mass of the crucible plus CaO (fwt 56.077 g/mol) was 26.7134 g. Calculate the concentration of Ca (fwt 40.078 g/mol) in the water in units of grams per 100 mL.

Calculating Results from Gravimetric Data• An iron ore was analyzed by dissolving a

1.1324 g sample in concentrated HCl. The resulting solution was diluted with water, and the iron(III) was precipitated as the hydrous oxide Fe2O3

.xH2O by addition of NH3. After filtration and washing, the residue was ignited at high temperature to give 0.5394 g pure Fe2O3 (fwt 159.69 g/mol). Calculate (a) the % Fe (fwt 55.847 g/mol) and (b) % Fe3O4 (fwt 231.54 g/mol) in the sample.

Calculating Results from Gravimetric Data • A 0.2356 g sample containing only NaCl

(fwt 58.44 g/mol) and BaCl2 (fwt 208.23 g/mol) yielded 0.4637 g of dried AgCl (fwt 143.32 g/mol). Calculate the percent of each halogen compound in the sample.

Documents

Section 09 Gravimetric Analysis(powerpoint)