Dando Sonic SDC375
Carrier Crawler mounted with multiple bolt-on track options -
Radio remote tracking with manual override - Lifting eyes as
standard
Levelling Jacks 4 Jack legs with counter balance valve
Deck Engine CAT C6 - 6.6l Turbocharged - 225HP - 24VDC
Drilling Mast Single box construction - 4.2m Head travel -
Hydraulic cylinder/chain driven system - Fully enclosed - Auto
tensioned -Pullback: 10,000 kgf
Mast Dump Allows for angle drilling to 45 degrees c/w support
struts.
Main Winch Maximum single line pull: 3200kgf - Maximum speed:
41m/minute- Drum capacity: 65m of 13mm wire rope
Water Pump FMC L1122 - 284 lpm - 1000 psi (other optional water
pump sizes available)
Hydraulic System
Hydraulic power circuit based on load sensing hydraulic pumps
and proportional control valves - 500l hydraulic reservoir
Sonic Head Model Sonicor 50K - Cross side - Head tilt
Hose Carrier System
High pressure hydraulic tubing - Enclosed in mast mounted energy
chain
Control Console Swing out control panel - Ergonomic
configuration - Key start - Remote throttle - Digital tachometer -
Pilot control valves
Breakout Table As standard - Double acting hydraulic make up and
break out clamp. With minimum clamping diameter of 60mm and a
maximum of 250mm. Other options available
Options Automatic single rod handler with 90 degree wrist
Double acting breakout table upgrade to 340mm
Lockable waterproof deck boxes x 2
Mast lighting package
Secondary oil cooler package
Auxiliary service lines with electrical, air and hydraulic quick
disconnects
Mast mounted automatic SPT trip hammer (63.5kg) - Complete with
electronic blow counter
Cold weather winterization package
Drilling Rig Specification
Dando Drilling International has been working in collaboration
with Sonic Drill Corporation, market leader for the sonic rig
industry and lead innovator in sonic drilling technology, to create
a brand new light, compact sonic drilling rig.
Sonic drilling boasts many advantages over conventional drilling
including being faster, requiring less drilling fluid, continuous
high quality coring and greatly reduced hole deviation.
Dando Drilling International
[email protected]
tel: +44 (0) 1903 731312fax: +44 (0)1903 730305
Please note: All figures and claims made here are indicative and
Dando Drilling Internationalreserves the right to make alterations
to specification detail without notice. All images are forreference
only and may not represent the exact specification outlined in this
document.
